Ads
related to: roof component diagram
Search results
Results from the WOW.Com Content Network
Section view through a house roof drawing showing names for parts of the structure. [clarification needed] (UK and Australia). Ctrs. means centers, a typical line to which carpenters layout framing. Domestic roof construction is the framing and roof covering which is found on most detached houses in cold and temperate climates. [1]
Two king post trusses linked to support a roof. Key:1: ridge beam, 2: purlins, 3: common rafters. This is an example of a "double roof" with principal rafters and common rafters. A timber roof truss is a structural framework of timbers designed to bridge the space above a room and to provide support for a roof.
Roof shapes include flat (or shed), gabled, hipped, arched, domed, and a wide variety of other configurations detailed below. [1]Roof angles are an integral component of roof shape, and vary from almost flat to steeply pitched.
The purlins are the large beams perpendicular to the rafters; from this shot, it appears that there are three purlins on either side of the roof. The sheathing boards are sometimes called the roof deck and are painted white. A purlin (or historically purline, purloyne, purling, perling) is a longitudinal, horizontal, structural member in a roof.
A roof (pl.: roofs or rooves) is the top covering of a building, including all materials and constructions necessary to support it on the walls of the building or on ...
Gambrel roof A cross-sectional diagram of a mansard roof, which is a hipped gambrel roof. A gambrel or gambrel roof is a usually symmetrical two-sided roof with two slopes on each side. The upper slope is positioned at a shallow angle, while the lower slope is steep.
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.
Eaves must be designed for local wind speeds as the overhang can significantly increase the wind loading on the roof. [ 7 ] The line on the ground under the outer edge of the eaves is the eavesdrip , or dripline, and in typical building planning regulations defines the extent of the building and cannot oversail the property boundary.
Ads
related to: roof component diagram