Search results
Results from the WOW.Com Content Network
A spring-loaded camming device (also SLCD, cam or friend) is a piece of rock climbing or mountaineering protection equipment. It consists of two, three, or four cams mounted on a common axle or two adjacent axles, so that pulling on the axle forces the cams to spread further apart. It is then attached to a sling and carabiner at the end of the ...
The rock-climbing equipment needed varies materially depending on the type of rock climbing being undertaken. Starting from the least equipment-intensive type of climbing, the general equipment needs are as follows: [1] Free solo climbing, and its deep-water soloing variant, require the least equipment as no climbing protection or ropes are used.
A typical helicopter has three flight control inputs: the cyclic stick, the collective lever, and the anti-torque pedals. [2] Depending on the complexity of the helicopter, the cyclic and collective may be linked together by a mixing unit , a mechanical or hydraulic device that combines the inputs from both and then sends along the "mixed ...
Black Diamond Equipment is a manufacturer of equipment for climbing, skiing, and mountain sports, based in Utah, United States. The company also has a global office in Innsbruck, Austria. The company is owned by Clarus Corporation, which also owns Pieps and ClimbOn! Skincare. [1] [2]
The Abalakov thread is a common method of protecting oneself while ice climbing because it is easy to create, does not require the sacrifice of expensive gear, and can be very safe when used properly. An Abalakov thread is often used in multi-pitch ice climbing routes. Because of its safety and convenience, the Abalakov thread is considered one ...
For climbing on with a fixed rope attached for security (for example, to snow anchors on a steep slope) only one ascender is used, keeping the other hand free for holding an ice axe. Ascenders are not used on free climbing routes, where a climber uses only their hands and feet on the features of the rock without artificial aids to gain ...
The top rope anchor point must be 1000 mm higher than the climbing wall and stand out 1000 mm from the wall. The layout for mounting the holds is based on a concept of square panels with a size of 1500 mm x 1500 mm each. Thus 20 panels, 10 vertically by 2 horizontally, form one of the two lanes.
Two sizes of metal standoffs and one plastic standoff. The background depicts a standoff in use, holding a circuit board above a metal case. A standoff is a threaded separator of defined length used to raise one part in an assembly above another. They are usually round or hex (for wrench tightening), often made of stainless steel, aluminum ...