enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Liquid latex - Wikipedia

   en.wikipedia.org/wiki/Liquid_latex

   Due to the presence of ammonium hydroxide, liquid latex may cause skin irritation and eye irritation. The amount of ammonium varies greatly, and depends on the latex's intended use. Liquid Latex intended for mold-making may cause serious eye irritation. [6] If liquid latex gets in your eyes, rinse cautiously with water for several minutes.

3. Talalay process - Wikipedia

   en.wikipedia.org/wiki/Talalay_process

   The Talalay process is a method of producing molded pieces of latex foam rubber. A liquid latex rubber base is introduced to a closed mold and is then vacuumed of air. The mold is then frozen to stabilize the cell structure. Carbon dioxide gas is introduced and the mold is heated to cure the rubber.

4. RTV silicone - Wikipedia

   en.wikipedia.org/wiki/RTV_silicone

   Silicones are usually very thick (high viscosity), and must be vacuum degassed prior to pouring, to minimize bubble entrapment. If making a brush-on rubber mold, the curing time factor between coats is long (longer than urethanes or polysulfides, shorter than latex). Silicone components (A+B) must be mixed accurately by weight (scale required ...

5. Foam latex - Wikipedia

   en.wikipedia.org/wiki/Foam_latex

   To create foam latex, a liquid latex base is mixed with various additives and whipped into a foam, then poured or injected into a mold and baked in an oven to cure.The main components of foam latex are the latex base, a foaming agent (to help it whip into a froth), a gelling agent (to convert the liquid foam into a gel), and a curing agent (to turn the gelled foam latex into a solid when baked).

6. How to Make a Jell-O Mold That Comes Out Perfect

   www.aol.com/jell-o-mold-comes-perfect-150003594.html

   Use hot water to remove a stubborn Jell-O mold: If your mold isn’t releasing from the pan, set the mold in a pan of hot water for 10 seconds and try to remove it again. Repeat the process until ...

7. Spin casting - Wikipedia

   en.wikipedia.org/wiki/Spin_casting

   The spin casting process typically uses vulcanized silicone or organic rubber as the mold-making substrate. Vulcanization is an integral step that occurs halfway through the mold-making process. Prior to vulcanization, the mold rubber is a soft and malleable solid-like fluid, in many ways very similar to Silly Putty. Because of the clay-like ...