Search results
Results from the WOW.Com Content Network
Front and side views of a 3-ring (mini rings) release system on a single riser of a packed main parachute. Since the introduction of the 3-ring system, variations in the design have raised safety concerns. For example, the move to mini rings and mini risers caused riser failures on some designs [6] until riser strength
RSL - Reserve Static Line RSL Shackle, held, and part of RSL shown installed in the container and attached to the main canopy riser RSL ring. A reserve static line, occasionally called a Stevens Lanyard or Stevens Release, is a device that automatically opens the reserve parachute container when the main parachute is cut-away.
The static line and D-Bag stay with the aircraft as the jumper leaves, and are pulled back into the aircraft by the dispatcher. Now free of its D-Bag, the canopy is allowed to inflate as the jumper continues to fall. Effectively, the jumper drags the parachute behind him, causing the upward-rushing wind to force open and inflate the canopy.
A main assisted reserve deployment (MARD) system is a skydiving safety device for parachute systems. While there are many variations, the operation and intended outcome for each is the same: open the reserve parachute container and extract the reserve parachute's deployment bag (and parachute) using the jettisoned main canopy.
Cut-away is a skydiving term referring to disconnecting the main parachute from the harness-container in case of a malfunction in preparation for opening the reserve parachute. The 3-ring release system on parachutes allows a rapid cut-away in the event of an emergency. Cutaway is also the title of a 2000 action film about skydiving.
CYPRES II panel. In skydiving, an automatic activation device (AAD) is a dead man's switch consisting of an electronic-pyrotechnic or mechanical device that automatically activates the opening sequence of the main or reserve parachute container when the AAD is falling below a preset altitude and above a preset decent speed.
After 54 weeks of recovery, Hinson went right back to doing one of the things he loved most: He went to the Parachute Center and jumped out of a plane. “It was an outlet for me,” he said.
3: Skydiver fights for main canopy. Main and reserve canopies assume biplane position (one of two possible positions where both canopies can work together). A malfunction [1] is a partial or total failure of a parachuting device to operate as intended. Malfunctions may require a skydiver to cut away their main parachute and deploy the reserve ...