enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   From top: Spade, brad point, masonry, and twist drills bits Drill bit (upper left), mounted on a pistol-grip electric drill A set of masonry drills. A drill bit is a cutting tool used in a drill to remove material to create holes, almost always of circular cross-section. Drill bits come in many sizes and shapes and can create different kinds of ...

3. Drill bit shank - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_shank

   Small (about 1 ⁄ 4 inch or 6.4 millimetres diameter) threaded drill bits and countersinks are common in aircraft metal work. Threaded drill bits may be held in drills meant to reach into very tight spaces, and threaded countersink cutters are widely used (along with finely adjustable depth stops) to create holes which put a matching rivet ...

4. Reamer - Wikipedia

   en.wikipedia.org/wiki/Reamer

   The geometry of a hole drilled in metal by a twist drill may not be accurate enough (close enough to a true cylinder of a certain precise diameter) and may not have the required smooth surface finish for certain engineering applications. Although modern twist drills can perform excellently in many cases—usually producing sufficiently accurate ...

5. Hole saw - Wikipedia

   en.wikipedia.org/wiki/Hole_saw

   Another advantage over drill bits is the wider size capability. For example, a 100 millimetres (3.9 inches) hole would require a huge twist drill or spade drill, unable to be properly driven by a pistol-grip drill or benchtop drill press; but it can be cut with a hole saw with relative ease. [5] Some disadvantages include: [6]

6. Drill - Wikipedia

   en.wikipedia.org/wiki/Drill

   Drill presses are almost always equipped with more powerful motors compared to hand-held drills. This enables larger drill bits to be used and also speeds up drilling with smaller bits. For most drill presses—especially those meant for woodworking or home use—speed change is achieved by manually moving a belt across a stepped pulley ...

7. Screw gun - Wikipedia

   en.wikipedia.org/wiki/Screw_gun

   A screw gun is similar to a power drill, but designed specifically for driving screws. A screw gun looks like a drill, but has a "nose" instead of a chuck. The nose holds an interchangeable 1 ⁄ 4-inch (6.4 mm) shank bit, commonly known as a tip. The most common types of tips are 1 inch (25 mm) No. 2 Phillips, T25 Torx, and flatheads.