Search results
Results from the WOW.Com Content Network
Pulsed DC is also commonly used in driving light-emitting diodes (LEDs) to lower the intensity. Since light-emitting diodes cannot be reliably dimmed through the simple reduction of voltage as in an incandescent bulb , pulsed DC is used to produce many rapid flashes of light that to the human eye are indiscernible as individual flashes, but are ...
Pulse-width modulation (PWM), also known as pulse-duration modulation (PDM) or pulse-length modulation (PLM), [1] is any method of representing a signal as a rectangular wave with a varying duty cycle (and for some methods also a varying period). PWM is useful for controlling the average power or amplitude delivered by an electrical signal.
In the electrical schematic shown, a typical light dimmer based on a silicon-controlled rectifier (SCR) dims the light through phase-angle control. This unit is wired in series with the load. Diodes (D2, D3, D4 and D5) form a bridge, which generates pulsed DC. R1 and C1 form a circuit with a time constant.
For premium support please call: 800-290-4726 more ways to reach us
PIII-process with ECR-plasma source and magnetron. Plasma-immersion ion implantation (PIII) [1] or pulsed-plasma doping (pulsed PIII) is a surface modification technique of extracting the accelerated ions from the plasma by applying a high voltage pulsed DC or pure DC power supply and targeting them into a suitable substrate or electrode with a semiconductor wafer placed over it, so as to ...
Pulsed operation of lasers refers to any laser not classified as continuous wave, so that the optical power appears in pulses of some duration at some repetition rate. [1] This encompasses a wide range of technologies addressing a number of different motivations. Some lasers are pulsed simply because they cannot be run in continuous mode.
Pulse electrolysis is an alternate electrolysis method that utilises a pulsed direct current to initiate non-spontaneous chemical reactions. [1] [2] [3] Also known as pulsed direct current (PDC) electrolysis, the increased number of variables that it introduces to the electrolysis method can change the application of the current to the electrodes and the resulting outcome.
In the non-tripped state, the outputs periodically pulse low. The protective device checks the output, to make sure it does indeed go low when commanded. If not, the output may have failed or has shorted to 24V somewhere else. Between OSSD1 and OSSD2 the pulse intervals are staggered to check for crisscrossed wiring between the two. [1]