Search results
Results from the WOW.Com Content Network
Following its competitors at Dodge and General Motors, Ford widened the front bodywork to integrate the cab and front fenders together. Going a step further, the F-Series integrated the hood into the bodywork with a clamshell design; [ 1 ] the feature would stay part of the F-Series for two decades.
Chevrolet trucks were denoted in a 10/20/30 series (for 1 ⁄ 2-ton, 3 ⁄ 4-ton, and 1-ton); GMC trucks returned as a 1500/2500/3500 series (badged 15/25/35 from 1973–80). While the Chevrolet Cheyenne and GMC Sierra names were carried over from the previous generation, this generation marked the introduction of the Chevrolet Silverado and ...
The hub assembly is located between the brake drums or discs and the drive axle. A wheel is bolted on it. Depending on the construction, the end of the hub comes equipped with the splined teeth. They mate the teeth on the axle shaft. The axle hub spins along with the wheels bolted to it and provide power to the wheels in order to rotate.
Maschinenfabrik Berthold Hermle AG is a publicly traded German company with headquarters in Gosheim, Baden-Württemberg, Germany. It is one of the leading manufacturers of milling machines . There are over 20,000 Hermle-manufactured machines in use worldwide.
Both companies used Dana 70 front axles until the mid-1970s (Dodge W300 pickup up until 1978, discontinued in 1979). All of these Dana 70 front axles were closed knuckle, with king pins and had a GAWR of 6000 lbs. Like the rear Dana 70 axles, the Dana 70 front axle started out with 23 spline axle shafts and then went to 35 spline axle shafts.
Now names in order from lightest to heaviest, the range started with the 1-short-ton (907 kg) Model 21 and continued with the 1 + 1 ⁄ 2-short-ton (1,361 kg) Model 31, 2-short-ton (1,814 kg) Model 41, 3-short-ton (2,722 kg) Model 61, and ended with the 5-short-ton (4,536 kg) Model 101; the Model 101 only entered production during 1922. [6]
The Dana 61 was made in semi-float and full-float axles for select 4×2 and 4x4 Ford 3 ⁄ 4-ton and 1 Ton Pickups and Vans from 1974 to 1987. A Dana 61 front axle was selectively used in Dodge 4×4 3 ⁄ 4-ton and 1 Ton pickups from 1987 to 1993. Although 3.07:1 and 3.31:1 gear sets are common for a Dana 61, lower gear sets deeper than (4.10:1 ...
While marketed solely as a two-door utility wagon, the Suburban was offered in 1 ⁄ 2-ton 10-series and 3 ⁄ 4-ton 20-series; a 1-ton C30 Suburban panel van was offered as an option (alongside the Chevrolet Van). From 1964 to 1988, the Chevrolet Veraneio was produced by GM Brazil as a five-door truck-based wagon.