Search results
Results from the WOW.Com Content Network
Wing ribs of a de Havilland DH.60 Moth. In an aircraft, ribs are forming elements of the airframe structure of a wing, especially in traditional construction.. By analogy with the anatomical definition of "rib", the ribs attach to the main spar, and by being repeated at frequent intervals, form a skeletal shape for the wing.
Good trainer planes and gliders can be made from SPADs. SPAD modelers make equally good advanced planes that can be made with corrugated plastic. They include: RC Airplane Combat, 3D Flying, and are preferred in places where the flyers would normally not risk a more expensive plane and yet want the same flying characteristics of balsa planes.
Hover You pull the aircraft into a completely vertical attitude and allow the propeller to hold the aeroplane in the air in plane much like a helicopter. This is the most basic 3D manoeuvre and usually the first one new modelers want to learn Torque Roll The plane is made to hover in place, rotating around its roll axis. This is an extension of ...
A radio-controlled aircraft (often called RC aircraft or RC plane) is a small flying machine that is radio controlled by an operator on the ground using a hand-held radio transmitter. The transmitter continuously communicates with a receiver within the craft that sends signals to servomechanisms (servos) which move the control surfaces based on ...
A typical metal spar in a general aviation aircraft usually consists of a sheet aluminium spar web, with L- or T-shaped spar caps being welded or riveted to the top and bottom of the sheet to prevent buckling under applied loads. Larger aircraft using this method of spar construction may have the spar caps sealed to provide integral fuel tanks.
The weight of the aircraft is the common factor that links all aspects of aircraft design such as aerodynamics, structure, and propulsion, all together. An aircraft's weight is derived from various factors such as empty weight, payload, useful load, etc. The various weights are used to then calculate the center of mass of the entire aircraft. [37]
The wing root of a simple aircraft, an American Aviation AA-1 Yankee, showing a wing root fairing. The wing root is the part of the wing on a fixed-wing aircraft or winged-spaceship that is closest to the fuselage, [1] and is the junction of the wing with the fuselage (not with a nacelle or any other body).
Basic aircraft control surfaces and motion. A)aileron B)control stick C)elevator D)rudder. Aircraft flight control surfaces are aerodynamic devices allowing a pilot to adjust and control the aircraft's flight attitude. Development of an effective set of flight control surfaces was a critical advance in the development of aircraft.