Search results
Results from the WOW.Com Content Network
A load line diagram, illustrating an operating point in the transistor's active region.. Biasing is the setting of the DC operating point of an electronic component. For bipolar junction transistors (BJTs), the operating point is defined as the steady-state DC collector-emitter voltage and the collector current with no input signal applied.
In a diode model two diodes are connected back-to-back to make a PNP or NPN bipolar junction transistor (BJT) equivalent. This model is theoretical and qualitative. This model is theoretical and qualitative.
Ebers–Moll model for an NPN transistor. [28] I B, I C and I E are the base, collector and emitter currents; I CD and I ED are the collector and emitter diode currents; α F and α R are the forward and reverse common-base current gains. Ebers–Moll model for a PNP transistor Approximated Ebers–Moll model for an NPN transistor in the ...
Figure 3: PNP version of the emitter-follower circuit, all polarities are reversed. A small voltage change on the input terminal will be replicated at the output (depending slightly on the transistor's gain and the value of the load resistance; see gain formula below). This circuit is useful because it has a large input impedance
For larger source impedances, the gain is determined by the resistor ratio R L / R S, and not by the transistor properties, which can be an advantage where insensitivity to temperature or transistor variations is important. An alternative to the use of the hybrid-pi model for these calculations is a general technique based upon two-port ...
The expressions are derived for a PNP transistor. For an NPN transistor, n has to be replaced by p, and p has to be replaced by n in all expressions below. The following assumptions are involved when deriving ideal current-voltage characteristics of the BJT [7] Low level injection; Uniform doping in each region with abrupt junctions
Darlington Transistor (NPN-type) In electronics, a Darlington configuration (commonly called as a Darlington pair) is a circuit consisting of two bipolar transistors with the emitter of one transistor connected to the base of the other, such that the current amplified by the first transistor is amplified further by the second one. [1]
Diode–transistor logic (DTL) is a class of digital circuits that is the direct ancestor of transistor–transistor logic. It is called so because the logic gating functions AND and OR are performed by diode logic , while logical inversion (NOT) and amplification (providing signal restoration) is performed by a transistor (in contrast with ...