Search results
Results from the WOW.Com Content Network
A theodolite is used to measure the horizontal angle between indicators on the two ends of the subtense bar. The distance from the telescope to the subtense bar is the height of an isosceles triangle formed with the theodolite at the upper vertex and the subtense bar length at its base, determined by trigonometry .
ESP32 is a series of low-cost, low-power system-on-chip microcontrollers with integrated Wi-Fi and dual-mode Bluetooth.The ESP32 series employs either a Tensilica Xtensa LX6 microprocessor in both dual-core and single-core variations, an Xtensa LX7 dual-core microprocessor, or a single-core RISC-V microprocessor and includes built-in antenna switches, RF balun, power amplifier, low-noise ...
(Previously, the height of the two Wi-Fi blocks was smaller than the height of the Bluetooth blocks.) Fixed formatting of the "elaboration information" in the Xtensa LX6 microprocessor block. Added descriptive text to diagram's title for conveying what the ESP32 is (it's a Wi-Fi & Bluetooth microcontroller) for clarity.
An optical sensor can measure the changes from one or several light beams. When a change occurs, the light sensor operates as a photoelectric trigger and therefore either increases or decreases the electrical output. An optical switch enables signals in optical fibers or integrated optical circuits to be switched selectively between circuits ...
Schematic diagram of an opto-isolator showing source of light (LED) on the left, dielectric barrier in the center, and sensor (phototransistor) on the right [note 1]. An opto-isolator (also called an optocoupler, photocoupler, or optical isolator) is an electronic component that transfers electrical signals between two isolated circuits by using light. [1]
Has an ATmega328 with Arduino bootloader, a dual H-bridge and additional prototyping space and headers. It is compatible with many shields, though four digital pins are used when operating the motor controller. Has an onboard voltage regulator, additional LEDs, a temperature sensor, and a light sensor. Part of the DFRobotShop Rover kit ...
A LED is a long-lived light source, but certain mechanisms can cause slow loss of efficiency of the device or sudden failure. The wavelength of the light emitted is a function of the band gap of the semiconductor material used; materials such as gallium arsenide , and others , with various trace doping elements , are used to produce different ...
In electronics, an LED circuit or LED driver is an electrical circuit used to power a light-emitting diode (LED). The circuit must provide sufficient current to light the LED at the required brightness, but must limit the current to prevent damaging the LED. The voltage drop across a lit LED is approximately constant over a wide range of operating