Search results
Results from the WOW.Com Content Network
Boot Camp combines Windows 10 with install scripts to load hardware drivers for the targeted Mac computer. Boot Camp currently supports Windows 10 on a range of Macs dated mid-2012 or newer. [ 9 ] Apple Silicon is not supported due to being ARM-based .
Double boot (also known as cold double boot, double cold boot, double POST, power-on auto reboot, or fake boot) is a feature of the BIOS, and may occur after changes to the BIOS' settings or the system's configuration, or a power failure while the system was in one of certain sleep modes.
Target Disk Mode (sometimes referred to as TDM or Target Mode) is a boot mode unique to Macintosh computers. When a Mac that supports Target Disk Mode [1] is started with the 'T' key held down, its operating system does not boot. Instead, the Mac's firmware enables its drives to behave as a SCSI, FireWire, Thunderbolt, or USB-C external mass ...
On system with BIOS firmware, the BIOS invokes MBR boot code from a hard disk drive at startup. The MBR boot code and the VBR boot code are OS-specific. In Microsoft Windows, the MBR boot code tries to find an active partition (the MBR is only 512 bytes), then executes the VBR boot code of an active partition.
Deploying solutions based on reboot to restore technology allows users to define a system configuration as the desired state. The baseline is the point that is restored on reboot. Once the baseline is set, the reboot to restore software continues to restore that configuration every time the device restarts or switches on after a shutdown. [3]
For a warm boot, the BIOS will be located in the proper place in RAM and the northbridge will direct the reset vector call to the RAM. In earlier PC systems, before chipsets were standard, the BIOS ROM would be located at an address range that included the reset vector, and BIOS ran directly out of ROM.
An MBR loader, such as Air-Boot, replaces the standard boot code in track 0 with code that displays a selection menu and loads the selected system. Some, e.g., Air-Boot, can be configured either automatically or by the user at boot time, rather than requiring an external configuration menu.
In Windows NT, the booting process is initiated by NTLDR in versions before Vista and the Windows Boot Manager (BOOTMGR) in Vista and later. [4] The boot loader is responsible for accessing the file system on the boot drive, starting ntoskrnl.exe, and loading boot-time device drivers into memory.