Search results
Results from the WOW.Com Content Network
Creating a proper plunger alignment is critical for correct flow and a long wear life. Stuffing box components are of stainless steel, brass or other application-specific materials. Compression packing is rigorously tested to ensure effective sealing in valves, pumps, agitators, and other rotary equipment.
Hydraulic pumps can also be used to start some engines through gears. The pumps are electrically controlled on the ground. A variation of this is the APU installed in a Boeing F/A-18 Hornet; it is started by a hydraulic motor, which itself receives energy stored in an accumulator.
The S type pump is useful for removing water from a well or container. Shallow well pumps are those in which the jet assembly is attached directly to the main pump and are limited to a depth of approximately 5-8m to prevent cavitation. Deep well pumps are those in which the jet is located at the bottom of the well. The maximum depth for deep ...
Each wing tank often has its own electric boost fuel pump, and each engine has its own mechanical pump, replicating the fuel system described above for the single engine. In case of single-engine operation, there is often a method incorporated to "cross-feed" the engine (left tank feeding right engine, or vice versa).
A 0.75 HP bore-well submersible pump which had been used to pump groundwater One style of submersible pump for industrial use. Outlet pipe and electrical cable not connected. A submersible pump (or electric submersible pump (ESP) is a device which has a hermetically sealed motor close-coupled to the pump body. The whole assembly is submerged in ...
Generally, axial pumps tend to give much lower pressures than centrifugal pumps, and a few bars is not uncommon. Their advantage is a much higher volumetric flowrate. For this reason they are common for pumping liquid hydrogen in rocket engines, because of its much lower density than other propellants which usually use centrifugal pump designs.
The Goulds Pumps/ITT Industries 200 was a NASCAR Busch Series race held at Nazareth Speedway in Nazareth, Pennsylvania. Originally a 300 lap race, it was added to the Busch Series schedule in 1988 and last run in 2004 , after the owners, International Speedway Corporation , closed the facility.
Commonly called 'Continuous Injection System (CIS) in the USA. K-Jetronic is different from pulsed injection systems in that the fuel flows continuously from all injectors, while the fuel pump pressurises the fuel up to approximately 5 bar (73.5 psi). The volume of air taken in by the engine is measured to determine the amount of fuel to inject.