Search results
Results from the WOW.Com Content Network
For example, 4K 60 Hz is possible using a single lane (e.g., Micro-USB / HDMI Type-A) with a DSC rate of 3.0×. [ 2 ] superMHL can use a variety of source and sink connectors with certain limitations: micro-USB or proprietary connectors can be used for the source only, HDMI Type-A for the sink only, while the USB Type-C [ 24 ] and the superMHL ...
EDID structure (base block) versions range from v1.0 to v1.4; all these define upwards-compatible 128-byte structures.Version 2.0 defined a new 256-byte structure but it has been deprecated and replaced by E-EDID which supports multiple extension blocks.
In VirtualLink mode, there were six high-speed lanes active in the USB-C connector and cable: four lanes transmit four DisplayPort HBR 3 video streams from the PC to the headset while two lanes implement a bidirectional USB 3.1 Gen 2 channel between the PC and the headset. Unlike the classic DisplayPort USB-C alternate mode, VirtualLink has no ...
The DL-41xx series came out in 2013. It is a USB 3.0 to LVDS device, supporting DL3 compression and HDCP 2.0 encryption. [26] It is designed to be embedded into monitors to enable USB as a video input on displays. It is described as a low-power device, which enables it to be powered from the USB bus without the need for an external power supply.
As a result, the first 4K monitors from 2013 and early 2014, such as the Sharp PN-K321, Asus PQ321Q, and Dell UP2414Q and UP3214Q, were addressed internally as two 1920 × 2160 monitors side by side instead of a single display and made use of DisplayPort's Multi-Stream Transport (MST) feature to multiplex a separate signal for each half over ...
USB-C plug USB-C (SuperSpeed USB 5Gbps) receptacle on an MSI laptop. USB-C, or USB Type-C, is a 24-pin connector (not a protocol) that supersedes previous USB connectors and can carry audio, video, and other data, to connect to monitors or external drives. It can also provide and receive power, to power, e.g., a laptop or a mobile phone.
For example, a USB 2 PCIe host controller card that presents 4 USB "Standard A" connectors typically presents one 4-port EHCI and two 2-port OHCI controllers to system software. When a high-speed USB device is attached to any of the 4 connectors, the device is managed through one of the 4 root hub ports of the EHCI controller.
The USB 3.1 specification takes over the existing USB 3.0's SuperSpeed USB transfer rate, now referred to as USB 3.1 Gen 1, and introduces a faster transfer rate called SuperSpeed USB 10 Gbps, corresponding to operation mode USB 3.1 Gen 2, [62] putting it on par with a single first-generation Thunderbolt channel.