Search results
Results from the WOW.Com Content Network
A superabsorbent polymer (SAP) (also called slush powder) is a water-absorbing hydrophilic homopolymers or copolymers [1] that can absorb and retain extremely large amounts of a liquid relative to its own mass. [2] Water-absorbing polymers, which are classified as hydrogels when mixed, [3] absorb aqueous solutions through hydrogen bonding with ...
The reaction results in a polymer which is also soluble in the chosen solvent. Heat released by the reaction is absorbed by the solvent, reducing the reaction rate. Moreover, the viscosity of the reaction mixture is reduced, preventing autoacceleration at high monomer concentrations. A decrease in viscosity of the reaction mixture by dilution ...
It is a common observation that when oil and water are poured into the same container, they separate into two phases or layers, because they are immiscible.In general, aqueous (or water-based) solutions, being polar, are immiscible with non-polar organic solvents (cooking oil, chloroform, toluene, hexane etc.) and form a two-phase system.
Super-absorbent polymers (SAP) similar to sodium polyacrylate were developed in the 1960s by the U.S. Department of Agriculture. [3] Before the development of these substances, the best water absorbing materials were cellulosic or fiber-based like tissue paper, sponge, cotton, or fluff pulp.
However, only solid→liquid and liquid→solid phase changes are practical for PCMs. Although liquid–gas transitions have a higher heat of transformation than solid–liquid transitions, liquid→gas phase changes are impractical for thermal storage because large volumes or high pressures are required to store the materials in their gas phase.
In materials science, liquefaction [1] is a process that generates a liquid from a solid or a gas [2] or that generates a non-liquid phase which behaves in accordance with fluid dynamics. [3] It occurs both naturally and artificially. As an example of the latter, a "major commercial application of liquefaction is the liquefaction of air to ...
In a liquid-liquid interface with monomer dissolved in one phase, polymerization occurs on only one side of the interface, whereas in liquid-liquid interfaces with monomer dissolved in both phases, polymerization occurs on both sides. [2] An interfacial polymerization reaction may proceed either stirred or unstirred.
The liquid molecules are more attracted to other liquid molecules as compared to the polymer surface. Because the polymer surfaces are solid surfaces, surface tension cannot be measured in a traditional way such as using a Wilhelmy plate. Instead, contact angles can be used to indirectly estimate the surface tension of polymer surfaces. [3]