Search results
Results from the WOW.Com Content Network
These disks cannot operate reliably at ATA/100 on RCC/ServerWorks IDE controllers, as their drivers blacklist the disks, thus limiting their operation to ATA/66. Barracuda ATA IV was the first generation of Barracuda ATA drives to be available exclusively with fluid dynamic bearings in spindle motors. Seagate announced their launch on June 27 ...
Device configuration overlay (DCO) is a hidden area on many of today's hard disk drives (HDDs). Usually when information is stored in either the DCO or host protected area (HPA), it is not accessible by the BIOS (or UEFI ), OS , or the user.
Serial ATA (SATA). The SATA data cable has one data pair for differential transmission of data to the device, and one pair for differential receiving from the device, just like EIA-422. That requires that data be transmitted serially. A similar differential signaling system is used in RS485, LocalTalk, USB, FireWire, and differential SCSI.
Hence, its protocol is usually ATA (a.k.a. PATA), SATA, SCSI, FC or SAS. The front-end interface communicates with a computer's host adapter (HBA, Host Bus Adapter) and uses: one of ATA, SATA, SCSI, FC; these are popular protocols used by disks, so by using one of them a controller may transparently emulate a disk for a computer.
Intended as a quick test to identify damage incurred during transporting of the device from the drive manufacturer to the computer manufacturer. [108] Only available on ATA drives, and it usually takes several minutes. Selective Some ATA drives allow selective self-tests of just a part of the surface. [109]
The SCSI commands and responses are embedded in "packets" (hence "ATA Packet Interface") for transmission on the ATA cable. This interfaces ATA with any device class for which a SCSI command set has been defined. ATAPI devices are also "speaking ATA" because the ATA physical interface and protocol are still being used to send the packets.
The ATA provides dial tone, ringing generator, DC power, caller ID data and other standard telephone line signaling (known collectively as BORSCHT) to the telephone connected to a modular jack. The digital interface of the ATA typically consists of an Ethernet port to connect to an Internet Protocol (IP) network, but may also be a USB port for ...
The ATA standard is supported by both parallel (IDE, PATA) and serial (SATA) ATA hardware. A drawback of the original ATA TRIM command is that it was defined as a non-queueable command and therefore could not easily be mixed with a normal workload of queued read and write operations. SATA 3.1 introduced a queued TRIM command to remedy this. [70]