enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Spin casting - Wikipedia

   en.wikipedia.org/wiki/Spin_casting

   The spin casting process typically uses vulcanized silicone or organic rubber as the mold-making substrate. Vulcanization is an integral step that occurs halfway through the mold-making process. Prior to vulcanization, the mold rubber is a soft and malleable solid-like fluid, in many ways very similar to Silly Putty. Because of the clay-like ...

3. Polymer clay - Wikipedia

   en.wikipedia.org/wiki/Polymer_clay

   Once conditioned, the clay will remain pliable until the particles eventually re-adhere. [8] Oven-hardenable PVC plastisol, "liquid polymer clay," is a complement to polymer clay that can be used as an adhesive to combine pieces, or to create various effects. Pigments, chalk pastel, and regular polymer clay can be added to make colored liquid clay.

4. Casting - Wikipedia

   en.wikipedia.org/wiki/Casting

   Plaster and other chemical curing materials such as concrete and plastic resin may be cast using single-use waste molds as noted above, multiple-use 'piece' molds, or molds made of small rigid pieces or of flexible material such as latex rubber (which is in turn supported by an exterior mold). When casting plaster or concrete, the material ...

5. RTV silicone - Wikipedia

   en.wikipedia.org/wiki/RTV_silicone

   RTV silicone rubber can be used to cast materials including wax, gypsum, low-melt alloys/metals, and urethane, epoxy, or polyester resins (without using a release agent). A more recent innovation is the ability to 3D print RTV silicones.

6. How to Make a Jell-O Mold That Comes Out Perfect

   www.aol.com/jell-o-mold-comes-perfect-150003594.html

   Use hot water to remove a stubborn Jell-O mold: If your mold isn’t releasing from the pan, set the mold in a pan of hot water for 10 seconds and try to remove it again. Repeat the process until ...

7. Molding (process) - Wikipedia

   en.wikipedia.org/wiki/Molding_(process)

   A mold or mould is a hollowed-out block that is filled with a liquid or pliable material such as plastic, glass, metal, or ceramic raw material. [2] The liquid hardens or sets inside the mold, adopting its shape. A mold is a counterpart to a cast. The very common bi-valve molding process uses two molds, one for each half of the object.

8. Michelle Obama Skips Jimmy Carter's Funeral and Is 'Still in ...

   www.aol.com/michelle-obama-skips-jimmy-carters...

   The former first lady was notably absent from President Jimmy Carter's state funeral service, leading Barack Obama and Donald Trump to be seated next to one another

9. Release agent - Wikipedia

   en.wikipedia.org/wiki/Release_agent

   The silicone keeps the rubber from sticking to the mold but just as important it lubricates the rubber so it will slide over the hot mold as it is loaded. Diluted silicone typically has to be applied every cycle. Semi-permanent mold release builds a silicone matrix on the mold that becomes a barrier between the rubber and the metal surface of ...