Ad
related to: rebuilt 350 tbi engine oil pump diagram
Search results
Results from the WOW.Com Content Network
The Chevrolet small-block engine refers to one of the several gasoline-powered vehicle engines manufactured by General Motors. These include: The first or second generation of non-LS Chevrolet small-block engines; The third, fourth, or fifth generation of LS-based GM engines; The Chevrolet Gemini small-block engine
All engines in this family share the same block dimensions and sometimes even the same casting number; the latter meaning engines were of the same block, but with different strokes (e.g., the casting number 3970010 was used by all three engines: 302, 327, and 350). This engine family was updated in 1968 for the use of 2.45 in (62.2 mm) medium ...
The oil pump is an internal combustion engine part that circulates engine oil under pressure to the rotating bearings, the sliding pistons and the camshaft of the engine. This lubricates the bearings, allows the use of higher-capacity fluid bearings and also assists in cooling the engine.
The gerotor-type oil pump was located at the bottom-rear of the engine, and provided oil to both the crankshaft main bearings and the cylinder heads (via the lifters and pushrods, as opposed to a drilled passage on LA engines). Chrysler's engineers also redesigned the oil seals on the crankshaft to improve anti-leak seal performance.
The 90° V6 engine uses the same transmission bellhousing pattern as the Chevrolet small-block V8 engine. The oil pan dipstick is located on the passenger side above the oil pan rail; this design was phased in on both the 90° V6 and Small Block Chevrolet assembly lines (for engines manufactured after 1979) sharing the same casting dies.
Being nearly identical, it too has the distinctive odd-sided hexagonal shape. These engines can be fitted in rear wheel drive vehicles with the right bellhousing and are used in hot rods, kit cars, sand rails and late model engine swaps. All Cadillac Northstar V8s; Oldsmobile Aurora L47 V8; GM 3.5L LX5 "Short Star" V6
The engine block had 4.84-inch (123 mm) bore centers, two-bolt main bearing caps, a "side oiling" lubrication system (the main oil gallery located low on the driver's side of the crankcase), with full-flow oil filter, and interchangeable cylinder heads. Heads used on the high performance 409 and 427 engines had larger ports and valves than ...
The Oldsmobile Diesel engine is a series of V6 and V8 diesel engines produced by General Motors from 1978 to 1985. Their design was based on the Olds 350 gasoline engine architecture. A 350 cu in (5.7 L) V8 was introduced in 1978, followed by a 261 cu in (4.3 L) V8 only for the 1979 model year.
Ad
related to: rebuilt 350 tbi engine oil pump diagram