Search results
Results from the WOW.Com Content Network
Soon after the .280 Remington came out, Fred Huntington reformed its case to an improved configuration with minimum body taper, a 35-degree shoulder angle, and called it the .280 RCBS. Since cases for the .280 RCBS could be formed by firing .280 Remington ammo in a rifle chambered for the former, Ackley abandoned the 7mm-06 Improved and started ...
The .280 Ackley Improved (.280 AI) was the result of the .280 Remington case modification by P.O Ackley, who pushed out the sidewalls at the shoulder to near parallel and steepened the shoulder angle to 40 degrees in order to increase powder capacity, thus along with increasing the allowable pressure, resulted in increasing the bullet initial velocity by approximately 100 fps.
The .280 cartridge at this stage had a rim diameter of .458 inch (11.6 mm), was 1.70 inches long (43 mm), and fired a 130 grain (8.4 g) bullet at 2,270 fps (692 m/s). In 1949 the rim diameter was increased to .473 inch (12 mm), the same as the United States' standard Caliber .30 ammunition, and redesignated .280/30, the bullet was changed to a ...
The .308 Winchester has a 3.64 mL (56 gr H 2 O) cartridge case capacity. [9] The exterior shape of the case was designed to promote reliable case feeding and extraction in bolt-action rifles and machine guns alike, under extreme conditions. .308 Winchester maximum C.I.P. cartridge dimensions. All dimensions in millimeters (mm) and inches.
One of these experimental cartridges was the .22 Eargesplitten Loudenboomer. This humorously named cartridge was developed by Ackley for Bob Hutton of Guns & Ammo magazine, and was intended solely to exceed 5,000 ft/s (1,500 m/s) muzzle velocity. Ackley's loads only managed 4,600 ft/s (1,400 m/s)(Mach 4.2), firing a 50-grain (3.2 g) bullet.
However, the ammo was much heavier (393 gr (25.4 g) for 7.62 x 51 round compared to 160 gr (10.4 g) for .45 ACP), effectively limiting the ammo load. Additionally, when fired in full automatic mode free recoil delivered by full-sized and full-powered cartridges became an issue, too.
The .280 Ross, also known as the .280 Nitro, .280 Rimless Nitro Express Ross (CIP) and .280 Rimless cartridge, is an approximately 7mm bullet diameter rifle round developed in Canada by F.W. Jones as a consultant to Sir Charles Ross, 9th Baronet, and his Ross Rifle Company of Quebec, Canada for use as a Canadian military cartridge as a replacement for the .303 British, and in a civilianised ...
Hand-loaded ammunition is permitted. For .308 / 7.62, match rifle would typically use bullets weighing between 190 and 230 grains, as opposed to the 155 grain bullets normally used in TR; A rest may be used to steady the hand supporting the rifle (a sling as used in TR is also an option), but the rifle may not be directly supported by a rest or ...