Search results
Results from the WOW.Com Content Network
In a steam engine, cutoff is the point in the piston stroke at which the inlet valve is closed. On a steam locomotive, the cutoff is controlled by the reversing gear.. The point at which the inlet valve closes and stops the entry of steam into the cylinder from the boiler plays a crucial role in the control of a steam engine.
With larger engines, the linkages involved in controlling cutoff and direction grew progressively heavier and there was a need for power assistance in adjusting them. Steam (later, compressed air) powered reversing gears were developed in the late 19th and early 20th centuries.
Collects steam at the top of the boiler (well above the water level) so that it can be fed to the engine via the main steam pipe, or dry pipe, and the regulator/throttle valve. [2] [5] [6]: 211–212 [3]: 26 Air pump / Air compressor Westinghouse pump (US+) Powered by steam, it compresses air for operating the train air brake system.
These diagrams were used to determine the efficiency of steam engines, such as those found aboard Western Rivers steamboats. Reason This image is of high technical standards, sufficient scalable resolution, is an excellent illustration of the related concepts, has a free license, supplements two separate articles, is accurate, has valuable ...
Diagram showing lap and lead and their relation to valve travel. When on the move, a steam locomotive requires steam to enter the cylinder at precise times relative to the piston's position. [3] This entails controlling the admission and exhaust of steam to and from the cylinders with a valve linked to the motion of the piston. [3]
The valves were quick acting, which reduced the amount of throttling of the steam and resulted in faster response. Instead of operating a throttling valve, the governor was used to adjust the valve timing to give a variable steam cut-off. The variable cut-off was responsible for a major portion of the efficiency increase of the Corliss engine. [19]
During the 1830s, the most popular valve drive for steam locomotives was known as gab motion in the United Kingdom and V-hook motion in the United States. [3] The gab motion incorporated two sets of eccentrics and rods for each cylinder; one eccentric was set to give forward and the other backwards motion to the engine and one or the other could accordingly engage with a pin driving the ...
The WHE-25 engine has a 34% cutoff. [4] This allows for the remaining 66% of the piston stroke to expand the steam, extracting work from it and causing the pressure to drop. The figure to the right shows how pressure in the cylinder of a steam engine drops after the cutoff point. The WHE-DR must have a much later cutoff to allow it to self-start.