Search results
Results from the WOW.Com Content Network
At stall, the torque converter can produce maximum torque multiplication if sufficient input power is applied (the resulting multiplication is called the stall ratio). The stall phase actually lasts for a brief period when the load (e.g., vehicle) initially starts to move, as there will be a very large difference between pump and turbine speed.
Tax or fiscal horsepower is a non-linear rating of a motor vehicle for tax purposes. [19] Tax horsepower ratings were originally more or less directly related to the size of the engine; but as of 2000, many countries changed over to systems based on CO 2 emissions, so are not directly comparable to older ratings.
This happened in 1993 for trucks, vans, and SUVs, and 1994 for rear wheel drive passenger cars. In 1996, a bolt-on bell housing was phased in (along with a six-bolt tailhousing) for S-10 Trucks and S-10 Blazers and beginning in 1998 for all other applications. Beginning in 1998 a new 300mm torque converter with improved higher-capacity ...
Brake horsepower per cubic centimeter or (bhp/cc) is a figure of merit that is used to indicate the 'state of tune' of an internal combustion engine. It is defined as the ratio of the engine's net power output to its displacement, the internal size. Power is measured at its rated speed and full throttle.
Mean effective pressure is also useful for initial design calculations; that is, given a torque, standard MEP values can be used to estimate the required engine displacement. However, mean effective pressure does not reflect the actual pressures inside an individual combustion chamber – although the two are certainly related – and serves ...
Known as an input speed sensor (ISS). This sensor sends a varying frequency signal to the TCU to determine the current rotational speed of the input shaft or torque converter. The TCU uses the input shaft speed to determine slippage across the torque converter and potentially to determine the rate of slippage across the bands and clutches. This ...
Torque converter, opened, interior similar to a retarder. A retarder is a device used to augment or replace some of the functions of primary friction-based braking systems, usually on heavy vehicles. Retarders serve to slow vehicles, or maintain a steady speed while traveling down a hill, and help prevent the vehicle from unintentional or ...
Released as the 6HP 26 in 2000, it was the first 6-speed automatic transmission in a production passenger car. Other variations of the first generation 6HP in addition to the 6HP 26, were 6HP19, and 6HP 32 having lower and higher torque capacity, respectively.