enow.com Web Search

  1. Ads

    related to: booster cables for dummies

Search results

  1. Results from the WOW.Com Content Network
  2. Boost converter - Wikipedia

    en.wikipedia.org/wiki/Boost_converter

    A boost converter or step-up converter is a DC-to-DC converter that increases voltage, while decreasing current, from its input (supply) to its output (load). It is a class of switched-mode power supply (SMPS) containing at least two semiconductors, a diode and a transistor, and at least one energy storage element: a capacitor, inductor, or the ...

  3. Quadrature booster - Wikipedia

    en.wikipedia.org/wiki/Quadrature_booster

    Quadrature booster. 400 MVA 220/155 kV phase-shifting transformer. A phase angle regulating transformer, phase angle regulator (PAR, American usage), phase-shifting transformer, phase shifter (West coast American usage), or quadrature booster (quad booster, British usage), is a specialised form of transformer used to control the flow of real ...

  4. Jumper (computing) - Wikipedia

    en.wikipedia.org/wiki/Jumper_(computing)

    In electronics and particularly computing, a jumper is a short length of conductor used to close, open or bypass part of an electronic circuit. They are typically used to set up or configure printed circuit boards, such as the motherboards of computers. The process of setting a jumper is often called strapping. [citation needed]

  5. Television antenna - Wikipedia

    en.wikipedia.org/wiki/Television_antenna

    A television antenna, also called a television aerial (in British English), is an antenna specifically designed for use with a television receiver (TV) to receive terrestrial over-the-air (OTA) broadcast television signals from a television station. Terrestrial television is broadcast on frequencies from about 47 to 250 MHz in the very high ...

  6. Power over Ethernet - Wikipedia

    en.wikipedia.org/wiki/Power_over_Ethernet

    The free polarity allows PoE to accommodate for crossover cables, patch cables and Auto MDI-X. In mode B, pins 4–5 (pair #1 in both T568A and T568B) form one side of the DC supply and pins 7–8 (pair #4 in both T568A and T568B) provide the return; these are the "spare" pairs in 10BASE-T and 100BASE-TX. Mode B, therefore, requires a 4-pair cable.

  7. Buck–boost converter - Wikipedia

    en.wikipedia.org/wiki/Buck–boost_converter

    The switch is typically a MOSFET, IGBT, or BJT. The buck–boost converter is a type of DC-to-DC converter that has an output voltage magnitude that is either greater than or less than the input voltage magnitude. It is equivalent to a flyback converter using a single inductor instead of a transformer. [1] Two different topologies are called ...

  8. 25-pair color code - Wikipedia

    en.wikipedia.org/wiki/25-pair_color_code

    25-pair telco cable pinout. A common application of the 25-pair color code is the cabling for the Registered Jack interface RJ21, which uses a female 50-pin miniature ribbon connector, as shown in the following table. The geometry of the pins of the receptacle (right hand image) corresponds to the pin numbers of the table.

  9. Coaxial cable - Wikipedia

    en.wikipedia.org/wiki/Coaxial_cable

    Coaxial cable, or coax (pronounced / ˈkoʊ.æks /), is a type of electrical cable consisting of an inner conductor surrounded by a concentric conducting shield, with the two separated by a dielectric (insulating material); many coaxial cables also have a protective outer sheath or jacket. The term coaxial refers to the inner conductor and the ...

  1. Ads

    related to: booster cables for dummies