Search results
Results from the WOW.Com Content Network
The engine block had 4.84-inch (123 mm) bore centers, two-bolt main bearing caps, a "side oiling" lubrication system (the main oil gallery located low on the driver's side of the crankcase), with full-flow oil filter, and interchangeable cylinder heads. Heads used on the high performance 409 and 427 engines had larger ports and valves than ...
The 400 saw extensive use in full-size Chevrolet and GMC trucks; K5 Blazer/Jimmy, 1/2-ton, 3/4-ton, 1-ton, and even larger 'medium duty' trucks had an option to be equipped with a 400. The engine was available in midsize A-Body and full-size B-Body passenger cars until the end of the 1976 model year. Early models produced 265 hp (198 kW) with a ...
Perkins Diesel Conversions & Factory fitted units, by Allan T. Condie, 2nd edition 2000, ISBN 0-907742-79-3 The 4 107T was used in UK Military electricity generating sets, the engines when in need an overhaul were rebuilt by a Kent based engineering works in Ramsgate, adjacent to the inner Harbour known as Walkers Marine (Marine Engineers) Ltd. Houchins of Ashford an MOD contractor would send ...
GM also made extensive use of economies of scale for the LS: with the exception of the 4.8L and 7.0L engines, all variants used the same 3.622" stroke (with most of those variants using the same basic crankshaft casting), the 4.8L and 5.3L variants utilized the same block casting, and several variants used the same length connecting rod. [39]
There was a U.S. auto industry-wide shift to lower compression ratios in mid-1971, so AMC increased combustion chamber size to 58-59 cc. The first three digits of the casting number on the large chamber heads are 321, 322, or 323 depending on year. The only difference between small and large chamber Gen-3 heads is the combustion chamber size.
The big-block engines initially used a forged crankshaft with a stroke of 3.975" for the 1965-1967 425 and 400 CID versions; starting in 1968, both the 400 cu in (6.6 L) and the 455 cu in (7.5 L) big blocks used a stroke of 4.25 in (108 mm), with crankshaft material changed to cast iron except in a few rare cases.
The L72 was a 427 cu in (7.0 L) 90° overhead valve V8 big-block engine produced by Chevrolet between 1966 and 1969. Initially rated at 450 horsepower, the rating dropped to 425 hp (317 kW) shortly after its release (although there was no change in power).
It had 2-bolt main bearing caps in 1969, but went to a block similar to the Ram Air IV's in 1969 that was drilled for 4-bolt main bearing caps (but used a cast crank and cast rods). In 1970 the casting number #9799914 Ram Air 400 4-bolt main block also used the 4-bolt main caps on Ram Air applications.