Search results
Results from the WOW.Com Content Network
Looked at simply, there are two methods to calculate the utilization rate. The first method calculates the number of billable hours divided by the number of hours recorded in a particular time period. For example, if 40 hours of time is recorded in a week but only 30 hours of that was billable, the utilization rate would then be 30 / 40 = 75%.
In scheduling, tardiness is a measure of a delay in executing certain operations and earliness is a measure of finishing operations before due time. The operations may depend on each other and on the availability of equipment to perform them.
Verification of the binary digits: 64 hours (Bellard formula), 66 hours (BBP formula) Verification of the binary digits were done simultaneously on two separate computers during the main computation. Both computed 32 hexadecimal digits ending with the 4,152,410,118,610th. [51] 90 days 5,000,000,000,000 = 5 × 10 12: 17 October 2011 Shigeru ...
The simplest example given by Thimbleby of a possible problem when using an immediate-execution calculator is 4 × (−5). As a written formula the value of this is −20 because the minus sign is intended to indicate a negative number, rather than a subtraction, and this is the way that it would be interpreted by a formula calculator.
The K Factor also helps calculate the peak-to-daily ratio of traffic. K30 helps maintain a healthy volume to capacity ratio. [3] K50 and K100 will sometimes be seen. K50 and K100 will not use the 30th highest hourly traffic volumes but the 50th or 100th highest hourly traffic volume when calculating the K factor.
Full Load hour is a measure of the degree of utilisation of a technical system. [1] [2] [3] Full load hours refer to the time for which a plant would have to be operated at nominal power in order to convert the same amount of electrical work as the plant has actually converted within a defined period of time, during which breaks in operation or partial load operation can also occur.
The advantage of the man-hour concept is that it can be used to estimate the impact of staff changes on the amount of time required for a task, which can done by dividing the number of man-hours by the number of workers available. For example, if a task takes 20 man-hours to complete then a team of 2 people will complete it in 10 hours of work ...
All-sky view of the 1998 Leonids shower. 156 meteors were captured in this 4-hour image.. In astronomy, the zenithal hourly rate (ZHR) of a meteor shower is the number of meteors a single observer would see in an hour of peak activity if the radiant was at the zenith, assuming the seeing conditions are perfect [1] (when and where stars with apparent magnitudes up to 6.5 are visible to the ...