Search results
Results from the WOW.Com Content Network
Anisotropic conductive film (ACF) is an adhesive interconnect system that is commonly used in panel display manufacturing, including liquid crystal displays (LCD) and organic light-emitting diode (OLED) technology. In display manufacturing, ACF facilitates the electrical and mechanical connections between the driver electronics and substrates.
This template has provisions for four sections: General characteristics, performance, armament, and avionics. What follows is list of the parameters that appear in each section, and specialised instructions for their use where necessary.
Front page of a floppy disk controller data sheet (1979) A datasheet, data sheet, or spec sheet is a document that summarizes the performance and other characteristics of a product, machine, component (e.g., an electronic component), material, subsystem (e.g., a power supply), or software in sufficient detail that allows a buyer to understand what the product is and a design engineer to ...
ARINC 429 is a data transfer standard for aircraft avionics. It uses a self-clocking, self-synchronizing data bus protocol (Tx and Rx are on separate ports). The physical connection wires are twisted pairs carrying balanced differential signaling. Data words are 32 bits in length and most messages consist of a single data word.
A three-component compatibility diagram will depict the stable phase of each pure component as the point at each corner of a ternary diagram. Additional points in the diagram represent other pure phases, and lines connecting pairs of these points represent compositions at which the two phases are the only phases present.
The amplifier was reissued for the first time in 1988 (the 1959S), and again from 1991 to 1993 (the 1959X) and from 1993 to 1995 (the 1959SLP). [1] The SLP continued after 1995 but in 2000 Marshall added modifications to lower the noise floor (hum balance pot), reverted the negative feedback resistor to the 1968-69 value of 47 kΩ, and added an effects loop.
ACF Industries, originally the American Car and Foundry Company (abbreviated as ACF), is an American manufacturer of railroad rolling stock. One of its subsidiaries was once (1925–54) a manufacturer of motor coaches and trolley coaches under the brand names of (first) ACF and (later) ACF-Brill .
The Mk 211 is a very popular .50 caliber sniper round used in the Barrett M82 rifle and other .50 BMG rifles. [5] It is also often used in heavy machine guns such as the M2 Browning, but not the M85. Due to its popularity, several U.S. arms manufacturers produce the round under license from NAMMO Raufoss AS. [6]