Search results
Results from the WOW.Com Content Network
A screw extractor held in a tap wrench. A screw extractor is a tool for removing broken or seized screws.There are two types: one has a spiral flute structure, commonly called an easy out after the trademarked name EZ-Out; [clarification needed] the other has a straight flute structure.
Key Seated Stuck Pipe. Key seating occurs when the drill string becomes off-centered in the wellbore, and the pipe collars become caught on a deviation in the wellbore. If the rig is able to move the drill string freely downhole, but every time the drill string is pulled upward it becomes stuck at the same point, then it is likely that the pipe ...
Assembled tremie placing concrete underwater Hopper, pipes and lifting cap components of a tremie concrete placement tube. A tremie is a watertight pipe, usually of about 250 mm inside diameter (150 to 300 mm), [1] with a conical hopper at its upper end above the water level. It may have a loose plug or a valve at the bottom end.
Screw clamps consist of a band, often galvanized or stainless steel, into which a screw thread pattern has been cut or pressed. One end of the band contains a captive screw. The clamp is put around the hose or tube to be connected, with the loose end being fed into a narrow space between the band and the captive screw.
A wood screw is a metal screw used to fix wood, with a sharp point and a tapered thread designed to cut its own thread into the wood. Some screws are driven into intact wood; larger screws are usually driven into a hole narrower than the screw thread, and cut the thread in the wood.
The rip fence is parallel to the saw blade and can be adjusted to different distances from the blade to set the size of the final cut. The fence remains static, while the workpiece is guided along the fence. [5] For crosscuts a sliding cross-cut fence or a mitre gauge – which incorporates a fence – is used.
Tripping pipe (or "Making a round trip" or simply "Making a trip") is the physical act of pulling the drill string out of the wellbore and then running it back in. This is done by physically breaking out or disconnecting (when pulling out of the hole) every other 2 or 3 joints of drill pipe at a time (called a stand ) and racking them ...
Where a fastener forms its own thread in the component being fastened, it is called a screw. [3] This is most obviously so when the thread is tapered (i.e. traditional wood screws), precluding the use of a nut, [3] or when a sheet metal screw or other thread-forming screw is used. A screw must always be turned to assemble the joint.