Search results
Results from the WOW.Com Content Network
Fan control is the management of the rotational speed of an electric fan. In computers, various types of computer fans are used to provide adequate cooling , and different fan control mechanisms balance their cooling capacities and noise they generate.
The link layer supports six different classes of message to permit the higher layers to distinguish data flits from non-data messages primarily for maintenance of cache coherence. In complex implementations of the QuickPath architecture, the link layer can be configured to maintain separate flows and flow control for the different classes.
From a control standpoint, the main difference between PECI and the previously used thermal monitoring methods is that PECI reports a negative value expressing the difference between the current temperature and the thermal throttle point (at which the CPU reduces speed or shuts down to prevent damage due to overheating) instead of the absolute ...
Where noise is an issue, larger, slower-turning fans are quieter than smaller, faster fans that can move the same airflow. Fan noise has been found to be roughly proportional to the fifth power of fan speed; halving the speed reduces the noise by about 15 dB. [22] Axial fans may rotate at speeds of up to around 38,000 rpm for smaller sizes. [23]
A governor, or speed limiter or controller, is a device used to measure and regulate the speed of a machine, such as an engine.. A classic example is the centrifugal governor, also known as the Watt or fly-ball governor on a reciprocating steam engine, which uses the effect of inertial force on rotating weights driven by the machine output shaft to regulate its speed by altering the input flow ...
In computer architecture, a control bus is part of the system bus and is used by CPUs for communicating with other devices within the computer. While the address bus carries the information about the device with which the CPU is communicating and the data bus carries the actual data being processed, the control bus carries commands from the CPU and returns status signals from the devices.
The control unit (CU) is a component of a computer's central processing unit (CPU) that directs the operation of the processor. A CU typically uses a binary decoder to convert coded instructions into timing and control signals that direct the operation of the other units (memory, arithmetic logic unit and input and output devices, etc.).
A control register is a processor register that changes or controls the general behavior of a CPU or other digital device. Common tasks performed by control registers include interrupt control, switching the addressing mode , paging control, and coprocessor control.