Search results
Results from the WOW.Com Content Network
Selection or a particular sampler type depends on the type of analysis to be performed (e.g. ambient water quality or wastewater), the type of water source (e.g. a lake or pond, small stream or large river, coastal waters or deep ocean) and other factors such as ambient environmental conditions (e.g. collection of stormwater during a rain event ...
Heated hoses are suitable for environments from -40°C to 80°C and can be used in explosion-proof zones 1/21 and 2/22, if required. [3] A heated hose consists of a flexible hose, through which the media is pumped. This hose determines the resistance against temperature and chemicals.
A rosette sampler is made of an assembly of 12 to 36 sampling bottles. [1] Each bottle is a volume that range from a minimum value of 1.2 L to a maximum value of 30 L. [1] The bottles are clustered around a cylinder situated in the center of the assembly, [1] where there is a sensing system called Sea-Bird or CTD, that stands for "Conductivity, Temperature and Depth", although other variables ...
A plankton net is equipment used for collecting samples of plankton in standing bodies of water. It consists of a towing line and bridles, nylon mesh net, and a cod end. Plankton nets are considered one of the oldest, simplest and least expensive methods of sampling plankton. [1] The plankton net can be used for both vertical and horizontal ...
The sea temperature at the water sampling depth is recorded by means of a reversing thermometer fixed to the Nansen bottle. This is a mercury thermometer with a constriction in its capillary tube which, when the thermometer is inverted, causes the thread to break and trap the mercury, fixing the temperature reading. [ 1 ]
Thermosyphon circulation in a simple solar water heater (not a working model; there is no water supply to replenish the tank when the tap is used). A thermosiphon (or thermosyphon) is a device that employs a method of passive heat exchange based on natural convection, which circulates a fluid without the necessity of a mechanical pump.
Bailers are tied to a piece of rope (usually made from nylon or polypropylene) or a piece of wire (composed of Teflon or stainless steel) and lowered into the water column. Once lowered, the bailer uses a simple ball check valve to seal at the bottom in order to pull up a sample of the groundwater table.
Closed Van Veen grab sampler. The Van Veen grab sampler is an instrument to sample sediment in water environments. Usually it is a clamshell bucket made of stainless steel. Up to 20 cm deep samples of roughly 0.1 m 2 can be extracted with this instrument. It can be light-weight (roughly 5 kg) and low-tech.