Search results
Results from the WOW.Com Content Network
Tube bending is any metal forming processes used to permanently form pipes or tubing. Tube bending may be form-bound or use freeform-bending procedures, and it may use heat supported or cold forming procedures. Form bound bending procedures like “press bending” or “rotary draw bending” are used to form the work piece into the shape of a ...
Piping or tubing is usually inserted into fittings to make connections. Connectors are assigned a gender, abbreviated M or F. An example of this is a "3 ⁄ 4-inch female adapter NPT", which would have a corresponding male connection of the same size and thread standard (in this case also NPT).
[13] [14] The total water extraction from center-pivot irrigation in the area is estimated to be about 5.42 million acre-feet of water per year. [15] In 1950, irrigated cropland covered 100,000 hectares (250,000 acres). With the use of center-pivot irrigation, nearly 1.2 million hectares (3 million acres) of land were irrigated in Kansas alone.
For instance, 1/2" PeX tubing is the same size as 1/2" copper tubing. 1/2" PVC on the other hand is not the same size as 1/2" tubing, and therefore requires either a threaded male or female adapter to connect them. When used in agricultural irrigation, the singular form "pipe" is often used as a plural. [27]
Consequently, a 1-inch (25 mm) copper pipe had a 1 + 1 ⁄ 8-inch (28.58 mm) outside diameter. The outside diameter was the important dimension for mating with fittings. The wall thickness on modern copper is usually thinner than 1 ⁄ 16-inch (1.6 mm), so the internal diameter is only "nominal" rather than a controlling dimension. [13] Newer ...
Rainguns are similar to impact sprinklers, except that they generally operate at very high pressures of 2.8 to 9.0 bar (280 to 900 kPa; 40 to 130 lbf/in 2) and flows of 3 to 76 L/s (50 to 1,200 US gal/min), usually with nozzle diameters in the range of 10 to 50 mm (0.5 to 1.9 in). In addition to irrigation, guns are used for industrial ...
RPZDs may also be known as reduced pressure principle (RP), reduced pressure principle backflow prevention devices, [1] [2] reduced pressure zone assemblies (RPZA), [3] or reduced pressure principle assembly (RPPA). [4] ASSE Standard 1013 - Reduced Pressure Backflow Assembly; ASSE Standard 1015 - Double Check Valve Assembly
Basin irrigation is favored in soils with relatively low infiltration rates. [1] This is also a method of surface irrigation. Fields are typically set up to follow the natural contours of the land but the introduction of laser levelling and land grading has permitted the construction of large rectangular basins that are more appropriate for ...