Search results
Results from the WOW.Com Content Network
Car key in ignition Car ignition and steering wheel lock. A car key or an automobile key is a key used to open and/or start an automobile. Modern key designs are usually symmetrical, and some use grooves on both sides, rather than a cut edge, to actuate the lock. It has multiple uses for the automobile with which it was sold.
Before Chrysler's 1949 innovation of the key-operated combination ignition-starter switch, [16] the starter was operated by the driver pressing a button that was mounted on the floor or dashboard. This type of control has now returned with the use of keyless entry. Early Chevrolet cars had the starter pedal to the right of the accelerator, with ...
A control valve is a valve used to control fluid flow by varying the size of the flow passage as directed by a signal from a controller. [1] This enables the direct control of flow rate and the consequential control of process quantities such as pressure , temperature , and liquid level.
Bleed screw key Bleed screw key in use at a domestic radiator. On a home radiator unit, the bleed screw can be opened, usually by means of a key, to allow unwanted air to escape from the unit. Bleed screws are also found on some pump types fulfilling a similar purpose. They are most often located at the top of the radiator on the side of the ...
An idle air control actuator or idle air control valve (IAC actuator/valve) is a device commonly used in fuel-injected vehicles to control the engine's idling rotational speed . [1] In carburetted vehicles a similar device known as an idle speed control actuator is used.
A check valve, non-return valve, reflux valve, retention valve, foot valve, or one-way valve is a valve that normally allows fluid (liquid or gas) to flow through it in only one direction. [1] Check valves are two-port valves, meaning they have two openings in the body, one for fluid to enter and the other for fluid to leave. There are various ...
Car hydraulics are equipment installed in an automobile that allows for a dynamic adjustment in height of the vehicle. These suspension modifications are often placed in a lowrider, i.e., a vehicle modified to lower its ground clearance below that of its original design. With these modifications, the body of the car can be raised by remote control.
Wastegate control and anti-lag; Theft prevention by blocking ignition, in response to input from an immobiliser; In a camless piston engine (an experimental design not currently used in any production vehicles), the ECU has continuous control of when each of the intake and exhaust valves are opened and by how much. [3] [4]