Search results
Results from the WOW.Com Content Network
Length. For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use. From 1893, the foot was legally defined as exactly 1200⁄3937 m (approximately 0.304 8006 m). [13] Since July 1, 1959, the units of length have been defined on the basis of 1 yd = 0 ...
The inch (symbol: in or ″) is a unit of length in the British Imperial and the United States customary systems of measurement. It is equal to 1 36 yard or 1 12 of a foot. Derived from the Roman uncia ("twelfth"), the word inch is also sometimes used to translate similar units in other measurement systems, usually understood as ...
The foot (standard symbol: ft) [1] [2] is a unit of length in the British imperial and United States customary systems of measurement. The prime symbol, ′, is commonly used to represent the foot. [3] In both customary and imperial units, one foot comprises 12 inches, and one yard comprises three feet.
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property ...
Table of length units. 1⁄12 of a ligne. This unit is usually called the Truchet point in English. Prior to the French Revolution the Fournier point was also in use. It was 1⁄6 of a ligne or 1⁄864 of the smaller French foot. 1⁄12 of a pouce. This corresponds to the line, a traditional English unit. 1⁄12 of a pied du roi.
statvolt (CGS unit) statV. ≘ c ⋅ (1 μJ/A⋅m) = 299.792458V. volt (SI unit) V. The difference in electric potential across two points along a conducting wire carrying one ampere of constant current when the power dissipated between the points equals one watt. [ 32 ] = 1 V = 1 W/A = 1 kg⋅m2/ (A⋅s3) = 1 J/C.
The units of cubic length (the cubic inch, cubic foot, cubic mile, etc.) are the same in the imperial and US customary systems, but they differ in their specific units of volume (the bushel, gallon, fluid ounce, etc.). The US customary system has one set of units for fluids and another set for dry goods. The imperial system has only one set ...
An input unit can be converted to any number of output units—the outputs are specified as a "combination" by separating unit codes with a space (" ") or a plus (" + "). Using a space as a separator does not work if any of the unit codes contains a space. For example, each of the following converts 1.2 km 2 to acres, square yards, and hectares.