Search results
Results from the WOW.Com Content Network
Partial melting. Partial melting is the phenomenon that occurs when a rock is subjected to temperatures high enough to cause certain minerals to melt, but not all of them. Partial melting is an important part of the formation of all igneous rocks and some metamorphic rocks (e.g., migmatites), as evidenced by a multitude of geochemical ...
Anatexis. Anatexis (via Latin from Greek roots meaning "to melt down") is the partial melting of rocks. [1] Traditionally, anatexis is used specifically to discuss the partial melting of crustal rocks, while the generic term "partial melting" refers to the partial melting of all rocks, in both the crust and mantle. [citation needed]
Eutectic system. A phase diagram for a fictitious binary chemical mixture (with the two components denoted by A and B) used to depict the eutectic composition, temperature, and point. (L denotes the liquid state.) A eutectic system or eutectic mixture (/ juːˈtɛktɪk / yoo-TEK-tik) [1] is a type of a homogeneous mixture that has a melting ...
Oceanic magmas likely result from partial melting of 3% to 15% of the source rock. [81] Some calk-alkaline granitoids may be produced by a high degree of partial melting, as much as 15% to 30%. [82] High-magnesium magmas, such as komatiite and picrite, may also be the products of a high degree of partial melting of mantle rock. [83]
The formation of pull-apart basins along strike-slip faults causes decompression melting. Advection of melts and heat flux into the lower crust results in partial melting of crustal rock. [16] The buoyant magma rises due to its lower density and is able to exploit weaknesses such as fault planes, using strike-slips as conduits for motion. [4]
Crystallization. In chemistry, fractional crystallization is a stage-wise separation technique that relies on the liquid-solid phase change. It fractionates via differences in crystallization temperature and enables the purification of multi-component mixtures, as long as none of the constituents can act as solvents to the others.
The mechanical properties of the asthenosphere are widely attributed to the partial melting of the rock. [4] It is likely that a small amount of melt is present through much of the asthenosphere, where it is stabilized by the traces of volatiles (water and carbon dioxide) present in the mantle rock. [2]
Partial melting of the existing crust increases the mafic content of the melt producing basaltic secondary crust. [14] A further method of formation due to the decay of radioactive elements within the Earth releasing heat energy and eventually causing the partial melting of upper mantle, also producing basaltic lavas. [15]