Search results
Results from the WOW.Com Content Network
Thermogravimetric analysis or thermal gravimetric analysis (TGA) is a method of thermal analysis in which the mass of a sample is measured over time as the temperature changes. . This measurement provides information about physical phenomena, such as phase transitions, absorption, adsorption and desorption; as well as chemical phenomena including chemisorptions, thermal decomposition, and ...
Differential thermal analysis (DTA) is a thermoanalytic technique that is similar to differential scanning calorimetry.In DTA, the material under study and an inert reference are made to undergo identical thermal cycles, (i.e., same cooling or heating programme) while recording any temperature difference between sample and reference. [1]
Piping and instrumentation diagram of pump with storage tank. Symbols according to EN ISO 10628 and EN 62424. A more complex example of a P&ID. A piping and instrumentation diagram (P&ID) is defined as follows: A diagram which shows the interconnection of process equipment and the instrumentation used to control the process.
Thermogravimetric Analysis (TGA) may be more useful for decomposition behavior determination. Impurities in polymers can be determined by examining thermograms for anomalous peaks, and plasticisers can be detected at their characteristic boiling points. In addition, examination of minor events in first heat thermal analysis data can be useful ...
Most thermomechanical instruments are force controlled, that is they apply a force, then measure a resulting change in a dimension of the test specimen. Usually a constant strain rate is used for stress–strain measurements, but in the case of df-TM the stress will be applied at a chosen rate.
An EGA instrument named the Thermal and Evolved-Gas Analyzer was flown on the Phoenix Lander probe that reached Mars in May 2008. Its purpose was to study Martian soil samples. [citation needed] An EGA instrument was contained within the Sample Analysis at Mars (SAM) instrument suite [2] onboard Curiosity Rover which landed on Mars in 2012. The ...
Temperature programmed desorption (TPD) is the method of observing desorbed molecules from a surface when the surface temperature is increased. When experiments are performed using well-defined surfaces of single-crystalline samples in a continuously pumped ultra-high vacuum (UHV) chamber, then this experimental technique is often also referred to as thermal desorption spectroscopy or thermal ...
Dynamic mechanical analysis (abbreviated DMA) is a technique used to study and characterize materials.It is most useful for studying the viscoelastic behavior of polymers.A sinusoidal stress is applied and the strain in the material is measured, allowing one to determine the complex modulus.