Search results
Results from the WOW.Com Content Network
The Herald, Vitesse, Spitfire, and GT6 all used a rear transverse leaf spring, as well as the 1995-98 Volvo 960/S90/V90 and a rare Swedish sports car incorporating the Volvo 960 rear suspension called the JC Indigo. [1]: 4 This type of suspension should not be confused with earlier, rigid axle applications such as those used on early Ford cars.
The torque tube design is typically heavier and securely ties the rear end together, thus providing a rigid rear end and assuring good alignment under all conditions. However, because of the greater unsprung weight of the torque tube and radius rods, there may be a "little hopping around of the rear end when cornering fast or on washboard roads".
With a beam axle, the camber angle between the wheels is the same regardless of its location in the travel of the suspension. A beam axle's location in the fore and aft directions is constrained by one of several suspension components, including trailing arms , semi-trailing arms, radius rods, and leaf springs .
An active suspension is a type of automotive suspension that uses an onboard control system to control the vertical movement of the vehicle's wheels and axles relative to the chassis or vehicle frame, rather than the conventional passive suspension that relies solely on large springs to maintain static support and dampen the vertical wheel movements caused by the road surface.
It would be typical for the force to vary up and down from this value. A variation between 90 and 110 N (20 and 25 lbf) would be characterized as a 20 N (5 lbf) lateral force variation (LFV). The lateral force variation can be expressed as a peak-to-peak value, which is the maximum minus minimum value, or any harmonic value as described above.
Rafter ties are designed to tie together the bottoms of opposing rafters on a roof, to resist the outward thrust where the roof meets the house ceiling and walls. This helps keep walls from spreading due to the weight of the roof and anything on it, notably wet snow. In many or most homes, the ceiling joists also serve as the rafter ties. When ...
Stirrup sample Stirrups form the outer part of a rebar cage. The function of stirrups (often referred to as 'reinforcing steel links' and 'shear links') is threefold: to give the main reinforcement bars structure, to maintain a correct level of concrete cover, and to maintain an equal transferance of force throughout the supporting elements. [ 30 ]
The circle of forces, traction circle, friction circle, [1] or friction ellipse [2] [3] [4] is a useful way to think about the dynamic interaction between a vehicle's tire and the road surface. The diagram below shows the tire from above, so that the road surface lies in the xy - plane .