Search results
Results from the WOW.Com Content Network
Typical use of TL431 in SMPS. Shunt resistor R3 maintains minimum TL431 current, series resistor R4 is part of frequency compensation network (C1R4) [31] [32] In the 21st century, the TL431, loaded with an optocoupler's light-emitting diode (LED), is the de facto industry standard solution for regulated switched-mode power supplies (SMPS).
IEEE 200-1975 or "Standard Reference Designations for Electrical and Electronics Parts and Equipments" is a standard that was used to define referencing naming systems for collections of electronic equipment. IEEE 200 was ratified in 1975. The IEEE renewed the standard in the 1990s, but withdrew it from active support shortly thereafter.
Despite their handling difficulties, and in the particular case of MELF resistors, they are still widely used in high-reliability and precision applications where their predictable characteristics (e.g., low failure rate with well-defined failure modes) as well as their higher performance in terms of accuracy, long-term stability, moisture resistance, high-temperature operation far outweigh ...
For example, a 10 ohm resistor connected in parallel with a 5 ohm resistor and a 15 ohm resistor produces 1 / 1/10 + 1/5 + 1/15 ohms of resistance, or 30 / 11 = 2.727 ohms. A resistor network that is a combination of parallel and series connections can be broken up into smaller parts that are either one or the other.
A varistor (a.k.a. voltage-dependent resistor (VDR)) is a surge protecting electronic component with an electrical resistance that varies with the applied voltage. [2] It has a nonlinear, non-ohmic current–voltage characteristic that is similar to that of a diode. Unlike a diode however, it has the same characteristic for both directions of ...
A resistance decade box, made in East Germany. A decade box is a piece of test equipment that can be used during prototyping of electronic circuits to substitute the interchanging of different values of certain passive components with a single variable output.
If only two terminals are used, one end and the wiper, it acts as a variable resistor or rheostat. The measuring instrument called a potentiometer is essentially a voltage divider used for measuring electric potential (voltage); the component is an implementation of the same principle, hence its name.
Three photoresistors with scale in mm Large CdS photocell from a street light. A photoresistor is less light-sensitive than a photodiode or a phototransistor.The latter two components are true semiconductor devices, while a photoresistor is a passive component that does not have a PN-junction.