Ads
related to: 30mm cantilever low mount adapter hose clamps for concrete anchors and accessories
Search results
Results from the WOW.Com Content Network
Riser clamp for a standpipe through-penetration firestop inside a fire hose cabinet under construction. A riser clamp is a type of hardware used by mechanical building trades for pipe support in vertical runs of piping (risers) at each floor level. The devices are placed around the pipe, and integral fasteners are then tightened to clamp them ...
The hose is then fit onto the barb, the clamp expanded again, slid onto the portion of the hose over the barb, then released, compressing the hose onto the barb. Clamps of this design are rarely used for high pressures or large hoses, as they would require unwieldy amounts of steel to generate enough clamping force, and be impossible to work ...
These pipe clamps are similar to hose clamps, but are heavier-duty and ideally are made completely of stainless steel (including the screw) to provide maximum service life. [ 21 ] : 149 [ 18 ] : 71 Optionally, the entire rubber sleeve may be jacketed with thin sheet metal, to provide extra stiffness, durability, and resistance to accidental ...
The anchor selection, together with additional reinforcement, and rigging arrangements is influenced by: - The dead weight of the element - The number of anchors in the element and the configuration of the anchor - Capacity of the anchor at the specific concrete compressive strengths at time of lift - The dynamic loads applied during lifting ...
Hose link is a 1/4-turn bayonet-mount garden hose connection, which uses an o-ring to o-ring seal. It was designed by Hoselink, Pty, Ltd., Australia, [24] and patented in 1998. [25] It is popular in Australia, with limited distribution in the UK and the US, where it is distributed by Dayco Products, Inc.
The cantilever snap-fit is the most commonly used snap-fit of the three. [6] [7] A cantilever design can be multiple use or permanent. A multiple-use snap-fit usually has a lever or pin to be pushed, in order to undo the snap-fit. However, on a permanent snap-fit there is no lever or pin.
Ads
related to: 30mm cantilever low mount adapter hose clamps for concrete anchors and accessories