Search results
Results from the WOW.Com Content Network
Pulse Doppler relies on medium pulse repetition frequency (PRF) from about 3 kHz to 30 kHz. Each transmit pulse is separated by 5 km to 50 km distance. Range and speed of the target are folded by a modulo operation produced by the sampling process. True range is found using the ambiguity resolution process. Ambiguity resolution process explanation
Other difficulties arise when the interference covariance matrix is ill-conditioned, making the inversion numerically unstable. [5] In general, this adaptive filtering must be performed for each of the unambiguous range bins in the system, for each target of interest (angle-Doppler coordinates), making for a massive computational burden. [4]
Pulse-Doppler systems measure the range to objects by measuring the elapsed time between sending a pulse of radio energy and receiving a reflection of the object. Radio waves travel at the speed of light , so the distance to the object is the elapsed time multiplied by the speed of light, divided by two – there and back.
The coarse structure; (the peaks or 'lobes' in the diagram on the left) and the Fine Structure which contains the individual frequency components as shown below. The envelope of the lobes in the coarse structure is given by: 1 π f {\displaystyle {\frac {1}{\pi \,f}}} .
Range ambiguity resolution is a technique used with medium pulse-repetition frequency (PRF) radar to obtain range information for distances that exceed the distance between transmit pulses. This signal processing technique is required with pulse-Doppler radar .
Measurement of a target's RCS is performed at a radar reflectivity range or scattering range. [citation needed] The first type of range is an outdoor range where the target is positioned on a specially shaped low RCS pylon some distance down-range from the transmitters. Such a range eliminates the need for placing radar absorbers behind the ...
The range and velocity of a target are detected through pulse delay ranging and the Doppler effect (pulse-Doppler), or through the frequency modulation (FM) ranging and range differentiation. The range resolution is limited by the instantaneous signal bandwidth of the radar sensor in both pulse-Doppler and frequency modulated continuous wave ...
The advantage of combining Doppler processing with pulse radars is to provide accurate velocity information. This velocity is called range-rate. It describes the rate that a target moves toward or away from the radar. A target with no range-rate reflects a frequency near the transmitter frequency and cannot be detected.