Search results
Results from the WOW.Com Content Network
A rod end bearing, also known as a heim joint (N. America) or rose joint (U.K. and elsewhere), is a mechanical articulating joint. Such joints are used on the ends of control rods, steering links , tie rods , or anywhere a precision articulating joint is required, and where a clevis end (which requires perfect 90-degree alignment between the ...
A threaded rod, also known as a stud, is a relatively long rod that is threaded on both ends; the thread may extend along the complete length of the rod. [1] They are designed to be used in tension. [2] Threaded rod in bar stock form is often called all-thread (ATR); other names include fully-threaded rod, redi-rod, continuously-threaded rod ...
The first 7075 was developed in secret by a Japanese company, Sumitomo Metal, in 1935, [3] but reverse engineered by Alcoa in 1943, after examining a captured Japanese aircraft. [4] 7075 was standardized for aerospace use in 1945. [5] 7075 was eventually used for airframe production in the Imperial Japanese Navy.
Typical material properties for 6005A aluminum alloy include: [2] Density: 2.71 g/cm 3, or 169 lb/ft 3. Electrical Conductivity: 47 to 50% IACS. Young's modulus: 70 GPa, or 10 Msi. Ultimate tensile strength: 190 to 300 MPa, or 28 to 44 ksi. Yield strength: 100 to 260 MPa, or 15 to 38 ksi. Thermal Conductivity: 180 to 190 W/m-K.
An aluminium alloy (UK/IUPAC) or aluminum alloy (NA; see spelling differences) is an alloy in which aluminium (Al) is the predominant metal. The typical alloying elements are copper , magnesium , manganese , silicon , tin , nickel and zinc .
7068 alloy is a 7000 series aluminium-zinc alloy registered with the US Aluminium Association and produced to AMS 4331 (chemical composition and mechanical properties) and AMS 2772 (heat treatment). 7068 alloy ‘A’ and ‘B’ tensile data and fatigue properties have been ratified for inclusion in MIL Handbook 5 / MMPDS.
BAlSi-5, AL 103: 90: 10: Al 88 Si 12: Al 575/585 [1] 577/582 [2] – BAlSi-4, AL 104, AL 718, L-ALSi12, BrazeTec L88/12. Free-flowing, most fluid of aluminium filler metals. General purpose filler metal, can be used with brazeable aluminiums in all types of brazing. For joining aluminium and its alloys.
Drill rod diameters range from 0.0135 to 1.5 in (0.34 to 38.10 mm); in the United States diameters smaller than 27 ⁄ 64 th of an inch (11 mm) are made in letter drill sizes and number drill sizes, in addition to fractional sizes. Lengths are usually one or three feet (0.3048 or 0.9144 m).