Search results
Results from the WOW.Com Content Network
A typical English sector, probably from the early 19th century, made of ivory with a brass hinge. This side has scales for lines of lines (L), secants (S), chords (C), and polygons (POL), along with a scale of 10ths of inches on the outer edges forming a straight 12-inch rule when the sector is fully opened, and a scale of 100ths of a foot marked along the side (only barely visible in this ...
To simplify the formula, the approximation is: The following can be used to find the versine of a given constant radius curve: [2] The Hallade method is to use the chord to continuously measure the versine in an overlapping pattern along the curve.
Two types of radius gauges. A radius gauge, also known as a fillet gauge, [1] is a tool used to measure the radius of an object. [2] Radius gauges require a bright light behind the object to be measured. The gauge is placed against the edge to be checked and any light leakage between the blade and edge indicates a mismatch that requires ...
Feeler gauge set (25 pieces, 0.03~1.0 mm measurement range) Measuring the valve clearance of a DOHC engine, between camshaft and tappet (here: 0.004 in ≈ 0.10 mm). A feeler gauge is a tool used to measure gap widths. Feeler gauges are mostly used in engineering to measure the clearance between two parts. [1]
Bend radius, which is measured to the inside curvature, is the minimum radius one can bend a pipe, tube, sheet, cable or hose without kinking it, damaging it, or shortening its life. The smaller the bend radius, the greater the material flexibility (as the radius of curvature decreases , the curvature increases ).
In the following equations, denotes the sagitta (the depth or height of the arc), equals the radius of the circle, and the length of the chord spanning the base of the arc. As 1 2 l {\displaystyle {\tfrac {1}{2}}l} and r − s {\displaystyle r-s} are two sides of a right triangle with r {\displaystyle r} as the hypotenuse , the Pythagorean ...
Having a constant diameter, measured at varying angles around the shape, is often considered to be a simple measurement of roundness.This is misleading. [3]Although constant diameter is a necessary condition for roundness, it is not a sufficient condition for roundness: shapes exist that have constant diameter but are far from round.
M - The mass of the accelerated shell or sheet of material (usually metal). The shell or sheet is often referred to as the flyer, or flyer plate. V or V m - Velocity of accelerated flyer after explosive detonation N - The mass of a tamper shell or sheet on the other side of the explosive charge, if present