enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Duct (flow) - Wikipedia

   en.wikipedia.org/wiki/Duct_(flow)

   Ducts commonly also deliver ventilation air as part of the supply air. As such, air ducts are one method of ensuring acceptable indoor air quality as well as thermal comfort. A duct system is also called ductwork. Planning (laying out), sizing, optimizing, detailing, and finding the pressure losses through a duct system is called duct design. [2]

3. Process duct work - Wikipedia

   en.wikipedia.org/wiki/Process_Duct_Work

   Process duct work conveys large volumes of hot, dusty air from processing equipment to mills, baghouses to other process equipment. Process duct work may be round or rectangular. Although round duct work costs more to fabricate than rectangular duct work, it requires fewer stiffeners and is favored in many applications over rectangular ductwork.

4. Heating, ventilation, and air conditioning - Wikipedia

   en.wikipedia.org/wiki/Heating,_ventilation,_and...

   Warm air systems distribute the heated air through ductwork systems of supply and return air through metal or fiberglass ducts. Many systems use the same ducts to distribute air cooled by an evaporator coil for air conditioning. The air supply is normally filtered through air filters [dubious – discuss] to remove dust and pollen particles. [15]

5. Duct (industrial exhaust) - Wikipedia

   en.wikipedia.org/wiki/Duct_(industrial_exhaust)

   Industrial exhaust ducts are pipe systems that connect hoods to industrial chimneys through other components of exhaust systems like fans, collectors, etc. Ducts are low-pressure pneumatic conveyors to convey dust, particles, shavings, fumes, or chemical hazardous components from air in the vicinity to a shop floor or any other specific locations like tanks, sanding machines, or laboratory hoods.

6. Ductwork airtightness - Wikipedia

   en.wikipedia.org/wiki/Ductwork_airtightness

   There are two major systems to classify ductwork airtightness, one based on European standards, the other based on ASHRAE standard 90.1-2010.Both are based on the leakage airflow rate at a given ductwork pressure divided by the product of the ductwork surface area and the same ductwork pressure raised to the power 0.65.

7. Register (air and heating) - Wikipedia

   en.wikipedia.org/wiki/Register_(air_and_heating)

   [4] [5] In contrast, returns (grilled ducts which suck air back into the HVAC system for heating or cooling) are usually placed in the wall or ceiling nearest the center of the building. Generally, in rooms where it is critical to maintain a constant temperature two registers (one placed near the ceiling to deliver cold air, and one placed in ...

8. Fanno flow - Wikipedia

   en.wikipedia.org/wiki/Fanno_flow

   The viscous friction causes the flow properties to change along the duct. The frictional effect is modeled as a shear stress at the wall acting on the fluid with uniform properties over any cross section of the duct. For a flow with an upstream Mach number greater than 1.0 in a sufficiently long duct, deceleration occurs and the flow can become ...

9. Ventilation (architecture) - Wikipedia

   en.wikipedia.org/wiki/Ventilation_(architecture)

   An early method of ventilation was the use of a ventilating fire near an air vent which would forcibly cause the air in the building to circulate. English engineer John Theophilus Desaguliers provided an early example of this when he installed ventilating fires in the air tubes on the roof of the House of Commons .