Search results
Results from the WOW.Com Content Network
The content could be general descriptive information, information on wiring and connections, test procedures, or piece-part replacement and repair information. The BSP documents were produced in primarily two formats, 8 1/2"x11" pages for use in office environments, and in a small, portable format (4" x 6 7/8") for use by installers on the job ...
Circuit components such as amplifiers can be tested using the two-tone method with a test setup like that shown in the figure. Two signal generators, set to two different frequencies F1 and F2, are fed into a power combiner through circulators. The combiner needs to have good isolation to prevent the signal from one generator being sent to the ...
Stubs are commonly used in antenna impedance matching circuits, frequency selective filters, and resonant circuits for UHF electronic oscillators and RF amplifiers. Stubs can be constructed with any type of transmission line: parallel conductor line (where they are called Lecher lines), coaxial cable, stripline, waveguide, and dielectric waveguide.
Entry-level cable testers are essentially continuity testers. A continuity tester is an item of electrical test equipment used to determine if an electrical path can be established between two points; [1] that is if an electrical circuit can be made. The circuit under test is completely de-energized prior to connecting the apparatus. [1]
IEC 60172 Test procedure for the determination of the temperature index of enamelled and tape wrapped winding wires; IEC 60183 Guidance for the selection of high-voltage A.C. cable systems; IEC 60188 High-pressure mercury vapour lamps – Performance specifications; IEC 60189 Low-frequency cables and wires with PVC insulation and PVC sheath
Longer cable runs are possible due to this increased noise immunity and 6 dB extra headroom. At higher frequencies, the output impedance of the output amplifier can change, resulting in a small imbalance. When driven in differential mode by two identical amplifiers, this impedance change will be the same for both lines, and thus cancelled out. [1]
Since hybrid circuits are bi-directional, they can be used to coherently combine power as well as splitting it. In figure 21, an example is shown of a signal split up to feed multiple low power amplifiers, then recombined to feed a single antenna with high power. [52] Figure 21.
In 1953, C-COR was the first to introduce cable powering which transmits power through coaxial cables for powering cable amplifiers. In 1965, it introduced the use of integrated circuits in amplifiers used on utility poles and in 1969 was the first to use heat fins on amplifiers.