Search results
Results from the WOW.Com Content Network
The intersection of a UTM zone and a latitude band is (normally) a 6° × 8° polygon called a grid zone, whose designation in MGRS is formed by the zone number (one or two digits – the number for zones 1 to 9 is just a single digit, according to the example in DMA TM 8358.1, Section 3-2, [1] Figure 7), followed by the latitude band letter ...
Under the Chairman of the Joint Chiefs of Staff Instruction CJCSI 3900.01C dated 30 June 2007, GARS was adopted for use by the US DoD as "the “area-centric” counterpart to the “point-centric” MGRS". It uses the WGS 1984 Datum and is based on lines of longitude (LONG) and latitude (LAT). It is intended to provide an integrated common ...
"Distortion of scale increases in each UTM zone as the boundaries between the longitude zones are approached." The distortion increases with the *metric* distance to the central meridian, thats why the west to east width of the UTM-Zones is limited to 800 km, btw. exactly 800 km, and that not because of the distortion but due to the concept ...
A projected coordinate system – also called a projected coordinate reference system, planar coordinate system, or grid reference system – is a type of spatial reference system that represents locations on Earth using Cartesian coordinates (x, y) on a planar surface created by a particular map projection. [1]
[20] [21] The six-degree zone width of UTM strikes a balance between the frequency of these discontinuities versus distortion of scale, which would increase unacceptably if the zones were made wider. (UTM further uses a 0.9996 scale factor at the central meridian, growing to 1.0000 at two meridians offset from the center, and increasing toward ...
In UTM, that line is 500,000 easting. 0 easting doesn't exist, it's in the zone to the west. So in MGRS/USNG, the squares on the edges of zones are clipped, but the squares on the west side still use the soutwest corner for 0,0 easting,northing, even though that's a possibly invalid point.
The Universal Transverse Mercator (UTM) is a map projection system for assigning coordinates to locations on the surface of the Earth. Like the traditional method of latitude and longitude , it is a horizontal position representation , which means it ignores altitude and treats the earth surface as a perfect ellipsoid .
Like the UTM coordinate system, the UPS coordinate system uses a metric-based cartesian grid laid out on a conformally projected surface. UPS covers the Earth's polar regions, specifically the areas north of 84°N and south of 80°S, which are not covered by the UTM grids, plus an additional 30 minutes of latitude extending into UTM grid to ...