Search results
Results from the WOW.Com Content Network
A taper pin is a fastener used in mechanical engineering. They are steel rods with one end having a slightly larger diameter than the other. Metric taper pins have a taper of 1:50. [1] A 1:50 taper means that one end of a 50 mm long bar will be 1 mm smaller in diameter than the other end.
The Martin Bridge is a steel truss bridge of eleven spans, each 37.1 metres (122 ft) long, on concrete supports, with three steel girder approach spans each 12.2 metres (40 ft) long. The total bridge length is 463 metres (1,519 ft). Originally it had a lifting span with two concrete counterbalances.
A taper pin is a self tightening device due to the shallow angle of the taper. They may be driven into the tapered hole such that removal can only be done with a hammer and punch. They are sized by a number sequence (for example, a No.4 reamer would use No.4 taper pins).
Attempts have been made to increase the safety of bridges with pin and hanger assemblies by adding some form of redundancy to the assembly. Retrofits that add redundancy to pin and hanger assemblies include adding a "catcher's mitt"—a short steel beam attached to the bottom of the cantilevered girder that extends out beneath the suspended girder to "catch" the suspended girder should ...
A taper insertion pin, also known as a taper, is a tool used for enlarging holes for body modification purposes. It is a long metal rod with one end having a slightly larger diameter than the other. Tapers are usually used for expanding piercings in order to accommodate larger plugs.
A split pin, also known as a cotter pin, or cotter key in the US, [1] is a metal fastener with two tines that are bent during installation, similar to a staple or rivet. Typically made of thick wire with a half-circular cross section, split pins come in multiple sizes and types.
Jason Day hits out of a green-side bunker on the 8th hole during the first round of the U.S. Open at Los Angeles Country Club. Pin placement green approaches.
Some drift pins are constructed with a taper, with the hammer acting on the large end of the taper. The tapered drift pin is used to align the two bolt holes in two separate components that are designed to mate. First the two components are maneuvered until the holes in each are in semi-alignment, such that the narrow end of the tapered drift ...