Search results
Results from the WOW.Com Content Network
The counter itself must count in Gray code, or if the counter runs in binary then the output value from the counter must be reclocked after it has been converted to Gray code, because when a value is converted from binary to Gray code, [nb 1] it is possible that differences in the arrival times of the binary data bits into the binary-to-Gray ...
Design an Elliptic filter with a pass band ripple of 1 dB from 0 to 1 rad/sec and a stop band ripple of 40 dB from at least 1.25 rad/sec to . Applying the calculations above for the value for n prior to applying the ceil() function, n is found to be 4.83721900 rounded up to the next integer, 5, by applying the ceil() function, which means a 5 ...
The critical path of a carry-skip-adder begins at the first full-adder, passes through all adders and ends at the sum-bit .Carry-skip-adders are chained (see block-carry-skip-adders) to reduce the overall critical path, since a single -bit carry-skip-adder has no real speed benefit compared to a -bit ripple-carry adder.
The carry-select adder generally consists of ripple-carry adders and a multiplexer.Adding two n-bit numbers with a carry-select adder is done with two adders (therefore two ripple-carry adders), in order to perform the calculation twice, one time with the assumption of the carry-in being zero and the other assuming it will be one.
For power-of-2 integer division, a simple binary counter can be used, clocked by the input signal. The least-significant output bit alternates at 1/2 the rate of the input clock, the next bit at 1/4 the rate, the third bit at 1/8 the rate, etc. An arrangement of flipflops is a classic method for integer-n division. Such division is frequency ...
An asynchronous (ripple) counter is a "chain" of toggle (T) flip-flops in which the least-significant flip-flop (bit 0) is clocked by an external signal (the counter input clock), and all other flip-flops are clocked by the output of the nearest, less significant flip-flop (e.g., bit 0 clocks the bit 1 flip-flop, bit 1 clocks the bit 2 flip ...
A binary ripple-carry adder works in the same way as most pencil-and-paper methods of addition. Starting at the least significant digit position, the two corresponding digits are added and a result is obtained. A 'carry out' may occur if the result requires a higher digit; for example, "9 + 5 = 4, carry 1".
Ripple (specifically ripple voltage) in electronics is the residual periodic variation of the DC voltage within a power supply which has been derived from an alternating current (AC) source. This ripple is due to incomplete suppression of the alternating waveform after rectification. Ripple voltage originates as the output of a rectifier or ...