Search results
Results from the WOW.Com Content Network
The voltage changes due to the transition from line-to-line to line-to-earth, typically reducing a 22 kV grid to 12.7 kV SWER or a 33 kV grid to 19.1 kV SWER. The SWER line is a single conductor that may stretch for tens or even hundreds of kilometres, with a number of distribution transformers along its length.
In electronics, voltage drop is the decrease of electric potential along the path of a current flowing in a circuit. Voltage drops in the internal resistance of the source, across conductors, across contacts, and across connectors are undesirable because some of the energy supplied is dissipated. The voltage drop across the load is proportional ...
Aluminum building wiring is a type of electrical wiring for residential construction or houses that uses aluminum electrical conductors. Aluminum provides a better conductivity-to-weight ratio than copper, and therefore is also used for wiring power grids, including overhead power transmission lines and local power distribution lines, as well ...
n {\displaystyle n} is the ideality factor, also known as the quality factor, emission coefficient, or the material constant. The equation is called the Shockley ideal diode equation when the ideality factor equals 1, thus is sometimes omitted. The ideality factor typically varies from 1 to 2 (though can in some cases be higher), depending on ...
Current loop. In electrical signalling an analog current loop is used where a device must be monitored or controlled remotely over a pair of conductors. Only one current level can be present at any time. A major application of current loops is the industry de facto standard 4–20 mA current loop for process control applications, where they are ...
slew rate effect on a square wave: red=desired output, green=actual output. In electronics and electromagnetics, slew rate is defined as the change of voltage or current, or any other electrical or electromagnetic quantity, per unit of time. Expressed in SI units, the unit of measurement is given as the change per second, but in the context of ...
Thévenin's theorem and its dual, Norton's theorem, are widely used to make circuit analysis simpler and to study a circuit's initial-condition and steady-state response. [ 8 ][ 9 ] Thévenin's theorem can be used to convert any circuit's sources and impedances to a Thévenin equivalent; use of the theorem may in some cases be more convenient ...
where u, v, and m are respectively the ultimate efficiency factor, the ratio of open-circuit voltage V op to band-gap voltage V g, and the impedance matching factor (all discussed above), and V c is the thermal voltage, and V s is the voltage equivalent of the temperature of the Sun. Letting t s be 1, and using the values mentioned above of 44% ...