enow.com Web Search

  1. Ads

    related to: 1 2 compression supply line for water tank

Search results

  1. Results from the WOW.Com Content Network
  2. Expansion tank - Wikipedia

    en.wikipedia.org/wiki/Expansion_tank

    An expansion tank or expansion vessel is a small tank used to protect closed water heating systems and domestic hot water systems from excessive pressure. The tank is partially filled with air, whose compressibility cushions shock caused by water hammer [ citation needed ] and absorbs excess water pressure caused by thermal expansion .

  3. Ballcock - Wikipedia

    en.wikipedia.org/wiki/Ballcock

    As the tank water level drops, the float descends and actuates the fill valve. Water is fed to the tank to replenish its supply, and a smaller flow is directed into the overflow tube to refill the bowl. Once the flapper valve closes, the water flow from the fill valve continues until the tank level again reaches the fill line.

  4. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    A trap primer automatically injects water into a trap, maintaining a water seal to keep sewer gas out of buildings. It must be installed in an easily accessible place for adjustment, replacement, and repair. A trap primer, a specialized valve, is usually connected to a clean-water supply in addition to a DWV system. [20]

  5. Copper tubing - Wikipedia

    en.wikipedia.org/wiki/Copper_tubing

    Because of its high level of corrosion resistance, it is used for water distribution systems, oil fuel transfer lines, non-flammable medical-gas systems, and as a refrigerant line in HVAC systems. [1] Copper tubing is joined using flare connection, compression connection, pressed connection, or solder. [2]

  6. Water tank - Wikipedia

    en.wikipedia.org/wiki/Water_tank

    An elevated water tank, also known as a water tower, will create a pressure at the ground-level outlet of 1 kPa per 10.2 centimetres (4.0 in) or 1 psi per 2.31 feet (0.70 m) of elevation. Thus a tank elevated to 20 metres creates about 200 kPa and a tank elevated to 70 feet creates about 30 psi of discharge pressure, sufficient for most ...

  7. Push-to-pull compression fittings - Wikipedia

    en.wikipedia.org/wiki/Push-to-pull_compression...

    A push-in compression coupling and tee.. Push-to-pull, push-to-connect, push-in, push-fit, or instant fittings are a type of easily removed compression fitting or quick connect fitting that allows an air (or water) line to be attached, nominally without the use of tools (a tool is still usually required for cutting tubing to length and removal).

  1. Ads

    related to: 1 2 compression supply line for water tank