Search results
Results from the WOW.Com Content Network
Compaction of ceramic powders is a forming technique for ceramics in which granular ceramic materials are made cohesive through mechanical densification, either by hot or cold pressing. The resulting green part must later be sintered in a kiln. The compaction process permits an efficient production of parts to close tolerances with low drying ...
Liquid phase sintering is the process of adding an additive to the powder which will melt before the matrix phase. The process of liquid phase sintering has three stages: rearrangement – As the liquid melts capillary action will pull the liquid into pores and also cause grains to rearrange into a more favorable packing arrangement.
Historically, liquid phase sintering was used to process ceramic materials like clay bricks, earthenware, and porcelain.Modern liquid phase sintering was first applied in the 1930s to materials like cemented carbides (e.g. WC-Co) for cutting tools, porous brass (Cu-Sn) for oil-less bearings, and tungsten-heavy alloys (W-Ni-Cu), but now finds applications ranging from superalloys to dental ...
Simulation of the outside of the Space Shuttle as it heats up to over 1,500 °C (2,730 °F) during re-entry into the Earth's atmosphere Bearing components made from 100% silicon nitride Si 3 N 4 Ceramic bread knife. Ceramic engineering is the science and technology of creating objects from inorganic, non-metallic materials. This is done either ...
Commercially available equipment for the AM of ceramics mostly relies on layer by layer sintering of powders and is rarely cost-effective. However, the difficulties in machining ceramic articles means that AM techniques can be attractive in situations where production volumes are too low to viably produce molds for slip
The sintering response of the investigated powder was studied by careful microstructural observations using scanning electron microscopy and optical microscopy both in reflection and transmission. The key to this method is to keep porosity intergranular during pre-sintering, so that it can be removed subsequently by HIP treatment.
Tape casting (also called doctor blading, knife coating, and shank shifting) [1] is a casting process used in the manufacture of thin ceramic tapes and sheets from ceramic slurry. [2] The ceramic slurry is cast in a thin layer onto a flat surface and then dried and sintered. [3] It's a part of powder metallurgy. [4]: 167
Because there is usually no pressing and sintering, glass-ceramics have no pores, unlike sintered ceramics. A wide variety of glass-ceramic systems exist, e.g., the Li 2 O × Al 2 O 3 × nSiO 2 system (LAS system), the MgO × Al 2 O 3 × nSiO 2 system (MAS system), and the ZnO × Al 2 O 3 × nSiO 2 system (ZAS system).