Search results
Results from the WOW.Com Content Network
The process flow diagram below depicts a typical semi-regenerative catalytic reforming unit. Schematic diagram of a typical semi-regenerative catalytic reformer unit in a petroleum refinery. The liquid feed (at the bottom left in the diagram) is pumped up to the reaction pressure (5–45 atm) and is joined by a stream of hydrogen-rich recycle gas.
A typical fluid catalytic cracking unit in a petroleum refinery. Fluid catalytic cracking (FCC) is the conversion process used in petroleum refineries to convert the high-boiling point, high-molecular weight hydrocarbon fractions of petroleum (crude oils) into gasoline, alkene gases, and other petroleum products.
A coker or coker unit is an oil refinery processing unit that converts the residual oil from the vacuum distillation column into low molecular weight hydrocarbon gases, naphtha, light and heavy gas oils, and petroleum coke.
Penex unit (simplified) The Penex process is a continuous catalytic process used in the refining of crude oil. It isomerizes light naphtha (C 5 /C 6) into higher-octane, branched C 5 /C 6 molecules. It also reduces the concentration of benzene in the gasoline pool. [1] It was first used commercially in 1958. [2]
A methane reformer is a device based on steam reforming, autothermal reforming or partial oxidation and is a type of chemical synthesis which can produce pure hydrogen gas from methane using a catalyst. There are multiple types of reformers in development but the most common in industry are autothermal reforming (ATR) and steam methane ...
Alternatively, iron sulfide present in the coal may have sufficient catalytic activity for the process, which was the original Bergius process. [2] The mixture is pumped into a reactor. The reaction occurs at between 400 and 500 °C and 20 to 70 MPa hydrogen pressure. The reaction produces heavy oils, middle oils, gasoline, and gases.
The factors involved include whether the amine unit is treating raw natural gas or petroleum refinery by-product gases that contain relatively low concentrations of both H 2 S and CO 2 or whether the unit is treating gases with a high percentage of CO 2 such as the offgas from the steam reforming process used in ammonia production or the flue ...
The catalytic recovery of sulfur consists of three substeps: heating, catalytic reaction and cooling plus condensation. These three steps are normally repeated a maximum of three times. Where an incineration or tail-gas treatment unit (TGTU) is added downstream of the Claus plant, only two catalytic stages are usually installed.