enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Electrical conduit - Wikipedia

   en.wikipedia.org/wiki/Electrical_conduit

   Intermediate metal conduit (IMC) is a steel tubing heavier than EMT but lighter than RMC. It may be threaded. Electrical metallic tubing (EMT), sometimes called thin-wall, is commonly used instead of galvanized rigid conduit (GRC), as it is less costly and lighter than GRC. EMT itself is not threaded, but can be used with threaded fittings that ...

3. Nominal Pipe Size - Wikipedia

   en.wikipedia.org/wiki/Nominal_Pipe_Size

   Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

4. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   For both of these rules of thumb (85%/90% and major minus pitch), the tap drill size yielded is not necessarily the only possible one, but it is a good one for general use. The 85% and 90% rules works best in the range of 1 ⁄ 4 –1 in (6.4–25.4 mm), the sizes most important on many shop floors. Some sizes outside that range have different ...

5. Annular cutter - Wikipedia

   en.wikipedia.org/wiki/Annular_cutter

   Annular cutters can also be used to make holes in pipes and tubes without dimpling and deburring. To make a hole in a tube or pipe easily an annular cutter should be used with a magnetic base drilling machine and a tube/pipe clamping device. The tube clamping device is a metallic device that is clamped on the tube with an adjustable chain.

6. Drill pipe - Wikipedia

   en.wikipedia.org/wiki/Drill_pipe

   Drill pipe, is hollow, thin-walled, steel or aluminium alloy piping that is used on drilling rigs. It is hollow to allow drilling fluid to be pumped down the hole through the bit and back up the annulus. It comes in a variety of sizes, strengths, and wall thicknesses, but is typically 27 to 32 feet in length (Range 2).

7. Pipe (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Pipe_(fluid_conveyance)

   For pipe sizes of NPS 14 inch (DN 350) and greater the NPS size is the actual diameter in inches and the DN size is equal to NPS times 25 (not 25.4) rounded to a convenient multiple of 50. For example, NPS 14 has an OD of 14 inches or 355.60 millimetres, and is equivalent to DN 350.

8. Bottom hole assembly - Wikipedia

   en.wikipedia.org/wiki/Bottom_hole_assembly

   A bottom hole assembly (BHA) is a component of a drilling rig. It is the lowest part of the drill string , extending from the bit to the drill pipe . The assembly can consist of drill collars, subs such as stabilisers, reamers, shocks, hole-openers, and the bit sub and bit.

9. Casing (borehole) - Wikipedia

   en.wikipedia.org/wiki/Casing_(borehole)

   Casing design for each size of designed pipes is done by calculating the worst conditions that may be faced during drilling and over the producing life of the well. Mechanical properties such as longitudinal tensile strength, and burst and collapse resistance (calculated considering biaxial effects of axial and hoop stresses), must be ...