Search results
Results from the WOW.Com Content Network
The Point-to-Point Protocol over Ethernet (PPPoE) is a network protocol for encapsulating Point-to-Point Protocol (PPP) frames inside Ethernet frames. It appeared in 1999, in the context of the boom of DSL as the solution for tunneling packets over the DSL connection to the ISP's IP network, and from there to the rest of the Internet.
The directed broadcast address for any IPv4 host can be obtained by taking the bit complement (bitwise NOT) of the subnet mask and then performing a bitwise OR operation with the host's IP address. A shortcut to this process (for common masks using only 0 and 1 bit placements) is to simply take the host's IP address and set all bits in the host ...
For example, IP uses IPCP, and Internetwork Packet Exchange (IPX) uses the Novell IPX Control Protocol . NCPs include fields containing standardized codes to indicate the network layer protocol type that the PPP connection encapsulates. The following NCPs may be used with PPP: IPCP for IP, protocol code number 0x8021, RFC 1332
The Point-to-Point Tunneling Protocol (PPTP) is an obsolete method for implementing virtual private networks.PPTP has many well known security issues. PPTP uses a TCP control channel and a Generic Routing Encapsulation tunnel to encapsulate PPP packets.
Internet Protocol over Ethernet (IPoE) is a method of delivering an IP payload over an Ethernet-based access network or an access network using bridged Ethernet over Asynchronous Transfer Mode (ATM) without using PPPoE. It directly encapsulates the IP datagrams in Ethernet frames, using the standard RFC 894 encapsulation.
IP-in-IP IP in IP (encapsulation) RFC 2003: 0x05 5 ST Internet Stream Protocol: RFC 1190, RFC 1819: 0x06 6 TCP Transmission Control Protocol: RFC 793: 0x07 7 CBT Core-based trees: RFC 2189: 0x08 8 EGP Exterior Gateway Protocol: RFC 888: 0x09 9 IGP Interior gateway protocol (any private interior gateway, for example Cisco's IGRP) 0x0A 10 BBN-RCC-MON
Thus the term static here refers to the nature of remaining unchanged by the system itself. The most prominent example of a static route is a default route which is often used on devices with a statically configured IP address to provide the device with access to the rest of the network or the internet by default. [3]
Most keyboard shortcuts require the user to press a single key or a sequence of keys one after the other. Other keyboard shortcuts require pressing and holding several keys simultaneously (indicated in the tables below by the + sign). Keyboard shortcuts may depend on the keyboard layout.