Search results
Results from the WOW.Com Content Network
Power op-amp with a maximal current output of 3 amperes [23] LM709 Yes General-purpose op-amp [24] LM741 LM709 General-purpose op-amp. [25] Widely used. LM747: Yes General-purpose dual op-amp. [26] LM748 General-purpose op-amp with external compensation [27] LM833 Dual high-speed audio operational amplifiers [28] LM837 Low-noise quadruple op ...
The tube is popular in hi-fi vacuum tube audio as a low-noise line amplifier, driver (especially for tone stacks), and phase-inverter in vacuum tube push–pull amplifier circuits. It was widely used, in special-quality versions such as ECC82 and 5814A, in pre-semiconductor digital computer circuitry.
The 5150 was based on the Soldano SLO-100 which Eddie Van Halen was using at the time and designed to provide high gain saturation as well as a clean channel. [5]While the product was designed around a centered printed circuit board (PCB), its cascading five preamps (actually four preamplifiers and one phase inverter) and four gain stages were implemented in a very simple manner.
The 400 BH power amp module was used in a range of bass amps during the early 1980s, commencing with the MKIII Bass Head in 1979. The MKIV Bass Amp head unit, introduced in 1981, offers a range of functions. It is air cooled, features protection circuitry, and is capable of around 300/350 watts RMS safely into 2 ohms.
The kit includes two AVR Raven boards, each with a 2.4 GHz transceiver supporting IEEE 802.15.4 (and a freely licensed Zigbee stack). The radios are driven with ATmega1284p processors, which are supported by a custom segmented LCD driven by an ATmega3290p processor.
In semiconductor devices, problems in the device package may cause failures due to contamination, mechanical stress of the device, or open or short circuits. Failures most commonly occur near the beginning and near the ending of the lifetime of the parts, resulting in the bathtub curve graph of failure rates.
The sensors which transimpedance amplifiers are used with usually have more capacitance than an op-amp can handle. The sensor can be modeled as a current source and a capacitor C i. [4] This capacitance across the input terminals of the op-amp, which includes the internal capacitance of the op-amp, introduces a low-pass filter in the feedback path.
The BeagleBoard is a low-power open-source single-board computer produced by Texas Instruments in association with Digi-Key and Newark element14.The BeagleBoard was also designed with open source software development in mind, and as a way of demonstrating the Texas Instrument's OMAP3530 system-on-a-chip. [8]